Skip to content
Please enter a keyword to search

  • CEI EN 60099-5 : 2014

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS

    Available format(s):  Hardcopy, PDF

    Superseded date:  22-03-2019

    Language(s):  English

    Published date:  01-01-2014

    Publisher:  Comitato Elettrotecnico Italiano

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 General principles for the application of surge arresters
    5 Surge arrester fundamentals and applications issues
    6 Insulation coordination and surge arrester applications
    7 Surge arresters for special applications
    8 Asset management of surge arresters
    Annex A (informative) - Determination of temporary
            overvoltages due to earth faults
    Annex B (informative) - Current practice
    Annex C (informative) - Arrester modelling techniques for
            studies involving insulation coordination and
            energy requirements
    Annex D (informative) - Diagnostic indicators of metal-oxide
            surge arresters in service
    Annex E (informative) - Typical data needed from arrester
            manufacturers for proper selection of surge arresters
    Annex F (informative) - Typical maximum residual voltages
            for metal-oxide arresters without gaps according
            to IEC 60099-4
    Annex G (informative) - Steepness reduction of incoming
            surge with additional line terminal surge capacitance
    Annex H (informative) - End of life and replacement of old
            gapped SiC-arresters
    Bibliography
    Annex ZA (normative) - Normative references to international
             publications with their corresponding
             European publications

    Abstract - (Show below) - (Hide below)

    Gives information, guidance, and recommendations for the selection and application of surge arresters to be used in three-phase systems with nominal voltages above 1 kV.

    General Product Information - (Show below) - (Hide below)

    Committee CT 37
    Development Note Classificazione CEI 37-3. (08/2001)
    Document Type Standard
    Publisher Comitato Elettrotecnico Italiano
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 62271-200:2011 High-voltage switchgear and controlgear - Part 200: AC metal-enclosed switchgear and controlgear for rated voltages above 1 kV and up to and including 52 kV
    EN 62271-1:2017 High-voltage switchgear and controlgear - Part 1: Common specifications for alternating current switchgear and controlgear
    IEC 60099-4:2014 Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems
    IEC TR 60071-4:2004 Insulation co-ordination - Part 4: Computational guide to insulation co-ordination and modelling of electrical networks
    IEC TS 60815-2:2008 Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 2: Ceramic and glass insulators for a.c. systems
    EN 62271-203:2012 High-voltage switchgear and controlgear - Part 203: Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV
    IEC TR 62271-300:2006 High-voltage switchgear and controlgear - Part 300: Seismic qualification of alternating current circuit-breakers
    EN 60099-4:2014 Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems
    IEC 60099-6:2002 Surge arresters - Part 6: Surge arresters containing both series and parallel gapped structures - Rated 52 kV and less
    EN 60507:2014 Artificial pollution tests on high-voltage ceramic and glass insulators to be used on a.c. systems
    IEC 62271-203:2011 High-voltage switchgear and controlgear - Part 203: Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV
    EN 60071-1:2006/A1:2010 INSULATION CO-ORDINATION - PART 1: DEFINITIONS, PRINCIPLES AND RULES
    IEC 62271-1:2017 High-voltage switchgear and controlgear - Part 1: Common specifications for alternating current switchgear and controlgear
    IEC 60071-2:1996 Insulation co-ordination - Part 2: Application guide
    IEC 60099-8:2017 Surge arresters - Part 8: Metal-oxide surge arresters with external series gap (EGLA) for overhead transmission and distribution lines of a.c. systems above 1 kV
    EN 60071-2:1997 Insulation co-ordination - Part 2: Application guide
    IEC 60507:2013 Artificial pollution tests on high-voltage ceramic and glass insulators to be used on a.c. systems
    IEC 60071-1:2006+AMD1:2010 CSV Insulation co-ordination - Part 1: Definitions, principles and rules
    IEC TS 60815-1:2008 Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 1: Definitions, information and general principles
    EN 62271-200:2012/AC:2015 HIGH-VOLTAGE SWITCHGEAR AND CONTROLGEAR - PART 200: AC METAL-ENCLOSED SWITCHGEAR AND CONTROLGEAR FOR RATED VOLTAGES ABOVE 1 KV AND UP TO AND INCLUDING 52 KV (IEC 62271-200:2011)
    IEC TS 60815-3:2008 Selection and dimensioning of high-voltage insulators intended for use in polluted conditions - Part 3: Polymer insulators for a.c. systems
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective