CEI EN 61347-2-7 : 2012

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for protective earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings of ballasts
14 Fault conditions
15 Starting conditions
16 Lamp current
17 Supply current
18 Maximum current in any lead (with cathode preheating)
19 Lamp operating current waveforms
20 Functional safety (EBLF)
21 Changeover operation
22 Recharging device
23 Protection against excessive discharge
24 Indicator
25 Remote control, rest mode, inhibition mode
26 Temperature cycling test and endurance test
27 Polarity reversal
28 Fault conditions
29 Construction
30 Creepage distances and clearances
31 Screws, current-carrying parts and connections
32 Resistance to heat, fire and tracking
33 Resistance to corrosion
34 Abnormal lamp conditions
35 Protection of associated components
Annex A (normative) - Test to establish whether a conductive
        part is a live part which may cause an electric shock
Annex B (normative) - Particular requirements for
        thermally protected lamp controlgear
Annex C (normative) - Particular requirements for electronic
        lamp controlgear with means of protection against
        overheating
Annex D (normative) - Requirements for carrying out the
        heating tests of thermally protected lamp controlgear
Annex E (normative) - Use of constant S other than
        4500 in t[w] tests
Annex F (normative) - Draught-proof enclosure
Annex G (normative) - Explanation of the derivation of the
        values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Batteries for emergency lighting
        luminaires
Annex J (normative) - Rest mode and inhibition mode
        facilities
Annex K (informative) - Ballasts incorporating an automatic
        testing function for emergency lighting operation
Annex L (normative) - Compatibility between normal
        mains operation electronic controlgear and battery
        powered emergency operation controlgear
Annex ZA (normative) - Normative references to international
        publications with their corresponding European
        publications

Describes the safety requirements for battery supplied electronic controlgear for maintained and non-maintained emergency lighting purposes.