CLC/TS 50131-2-7-3:2009

1 Scope
2 Normative references
3 Terms, definitions and abbreviations
  3.1 Terms and definitions
  3.2 Abbreviations
4 Functional requirements
  4.1 Event processing
  4.2 Operational requirements
  4.3 Detection
  4.4 Immunity to false alarm sources
  4.5 Tamper security
  4.6 Electrical requirements
  4.7 Environmental classification and conditions
5 Marking, identification and documentation
  5.1 Marking and/or identification
  5.2 Documentation
6 Testing
  6.1 General test conditions
  6.2 Basic detection test
  6.3 Performance tests
  6.4 Switch-on delay, time interval between signals
       and indication of detection
  6.5 Fault condition signals or messages: self tests
  6.6 Tests of immunity to false alarm sources
  6.7 Tamper security
  6.8 Electrical tests
  6.9 Environmental classification and conditions
  6.10 Marking, identification and documentation
Annex A (normative) - Catalogue of standard glass types
Annex B (normative) - List of small tools suitable for
        testing immunity of casing to attack
Annex C (normative) - Dimensions & requirements of a
        standard test magnet
  C.1 Normative references
  C.2 Requirements
Annex D (normative) - Immunity test: Small objects
        hit sensitivity
Annex E (normative) - Immunity test: Soft objects hit
        sensitivity
Annex F (normative) - Immunity test: Hard objects hit
        sensitivity
Annex G (normative) - Immunity test: Static pressure
        sensitivity
Annex H (normative) - Immunity test: Dynamic pressure
        sensitivity
Annex I (normative) - General testing matrix
Annex J (normative) - Performance test setup
  J.1 Performance test setup
  J.2 Alternative performance test setup
Annex K (normative) - Performance sensitivity test

This Technical Specification is for active surface mounted glass break detectors installed in buildings and provides for security grades 1 to 4 (see EN 50131 1), specific or non-specific wired or wire-free detectors and uses environmental classes I to IV (see EN 50130 5). This Technical Specification does not include requirements for active surface mounted glass break detectors intended for use outdoors. A detector shall fulfil all the requirements of the specified grade. Functions additional to the mandatory functions specified in this standard may be included in the detector, providing they do not adversely influence the correct operation of the mandatory functions. This Technical Specification does not apply to system interconnections.