DD CLC/TS 50131-2-7-2:2009

1 Scope
2 Normative references
3 Terms, definitions and abbreviations
  3.1 Terms and definitions
  3.2 Abbreviations
4 Functional requirements
  4.1 Event processing
  4.2 Operational requirements
  4.3 Detection
  4.4 Immunity to false alarm sources
  4.5 Tamper security
  4.6 Electrical requirements
  4.7 Environmental classification and conditions
5 Marking, identification and documentation
  5.1 Marking and/or identification
  5.2 Documentation
6 Testing
  6.1 General test conditions
  6.2 Basic detection test
  6.3 Performance tests
  6.4 Switch-on delay, time interval between signals
       and indication of detection
  6.5 Fault condition signals or messages: self tests
  6.6 Tests of immunity to false alarm sources
  6.7 Tamper security
  6.8 Electrical tests
  6.9 Environmental classification and conditions
  6.10 Marking, identification and documentation
Annex A (normative) - Catalogue of standard glass
        types
Annex B (normative) - List of small tools suitable for
        testing immunity of casing to attack
Annex C (normative) - Dimensions & requirements of
        a standard test magnet
  C.1 Normative references
  C.2 Requirements
Annex D (normative) - Immunity test: Small objects hit
        sensitivity
Annex E (normative) - Immunity test: Soft objects hit
        sensitivity
Annex F (normative) - Immunity test: Hard objects hit
        sensitivity
Annex G (normative) - Immunity test: Static pressure
        sensitivity
Annex H (normative) - Immunity test: Dynamic pressure
        sensitivity
Annex I (normative) - General testing matrix
Annex J (normative) - Performance test setup
  J.1 Performance test setup
  J.2 Alternative performance test setup
Annex K (normative) - Performance sensitivity test

Applies for passive surface mounted glass break detectors installed in buildings and provides for security grades 1 to 4, specific or non-specific wired or wire-free detectors and uses environmental classes I to IV.