DEFSTAN 02-703/2(2011) : 2011
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
THERMAL AND ACOUSTIC INSULATION OF HULL AND MACHINERY
Hardcopy , PDF
27-02-2023
English
01-01-2011
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Warning
3 Normative References
4 Materials Safety
5 Abbreviations
6 Thermal Insulation - General Principles
7 Acoustic Treatment - General Principles
8 Selection of Contractors
9 Thermal Insulation - Structure - Surface Ships
10 Acoustic Treatment Structure - Surface Ships
11 Thermal Insulation - Structure - Submarines
12 Fire Barrier Insulation
13 Thermal Insulation - Ventilation Trunking -
Surface Ships
14 Thermal Insulation - Ventilation Trunking -
Submarines
15 Acoustic Treatment - Ventilation Trunking -
Surface Ships and Submarines
16 Thermal and Acoustic Insulation - Voice
Pipes - Surface Ships
17 Thermal Insulation - Piping At 80 degrees C and
Below - Surface Ships and Submarines
18 Thermal Insulation - Piping Above 80 degrees
C - Surface Ships and Submarines
19 Thermal Insulation - Drains from Hot Equipment -
Surface Ships and Submarines
20 Thermal Insulation - Steam Turbine Cylinders, Drain
Coolers, Heat Exchangers, Pumps - Surface Ships
and Submarines
21 Thermal Insulation - WT Boilers and Back up Insulation
to Furnace Lining - Surface Ships
22 Thermal Insulation - Boiler Uptakes - Surface Ships
23 Thermal Insulation - Diesel Engine Exhaust Systems -
Surface Ships and Submarines
24 Thermal and Acoustic Insulation - Gas Turbine
Uptakes - Surface Ships
Annex A - Normative References
Annex B - MODLAG Modular Insulation - Surface Ships
and Submarines
Describes requirements for the thermal, fire barrier and acoustic insulation of the structure and where appropriate, the systems, ventilation trunking and machinery of HM Ships and Submarines.
| DevelopmentNote |
Supersedes DEFSTAN 02-703/1(2000). (06/2011) This standard is obsolescent because it is no longer required for procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (08/2016)
|
| DocumentType |
Standard
|
| Pages |
106
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| DEFSTAN 02-801/2(2015) : 2015 | REQUIREMENTS FOR GLASS FIBRE PRODUCTS FOR USE IN THERMAL INSULATION APPLICATIONS |
| DEFSTAN 02-319/4(2014) : 2014 | REQUIREMENTS FOR AVIATION FUEL SYSTEMS IN HM SHIPS |
| DEFSTAN 02-803/2(2015) : 2015 | REQUIREMENTS FOR POLYMER FOAMS FOR THERMAL INSULATION |
| DEFSTAN 02-123(PT1)/3(2015) : 2015 | REQUIREMENTS FOR LAUNDRIES AND ASSOCIATED COMPARTMENTS - PART 1: LAUNDRIES AND ASSOCIATED COMPARTMENTS |
| DEFSTAN 02-330/3(2013) : 2013 | REQUIREMENTS FOR MAIN PROPULSION PLANT CONDENSERS IN NUCLEAR POWERED SUBMARINES |
| DEFSTAN 02-332/2(2013) : 2013 | REQUIREMENTS FOR FEED, STEAM AND DRAIN SYSTEMS FOR NUCLEAR SUBMARINE PROPULSION AND GENERATING MACHINERY |
| DEFSTAN 02-121(PT1)/4(2017) : 2017 | REQUIREMENTS FOR GALLEYS AND ASSOCIATED SPACES (CATEGORY 2) - PART 1: COMMON REQUIREMENTS |
| DEFSTAN 00-133(PT0)/1(2014) : 2014 | AVIATION ARRANGEMENTS IN SURFACE SHIPS - PART 0: PROCEDURES FOR USE, DEFINITIONS AND CONTENT |
| DEFSTAN 02-329/4(2015) : 2015 | REQUIREMENTS FOR HEAT EXCHANGERS FOR HM SURFACE SHIPS AND SUBMARINES |
| DEFSTAN 02-804/2(2015) : 2015 | REQUIREMENTS FOR CORK PRODUCTS FOR THERMAL INSULATION |
| DEFSTAN 02-320/4(2015) : 2015 | REQUIREMENTS FOR THE DESIGN AND INSTALLATION OF FUEL SYSTEMS FOR GAS TURBINE ENGINES AND DIESEL ENGINES IN HM SURFACE SHIPS AND SUBMARINES |
| DEFSTAN 02-802/2(2015) : 2015 | REQUIREMENTS FOR MINERAL WOOL PRODUCTS FOR ACOUSTIC AND THERMAL INSULATION |
| DEFSTAN 00-133(PT0)/2(2015) : 2015 | AVIATION ARRANGEMENTS IN SURFACE SHIPS - PART 0: PROCEDURE FOR USE, DEFINITIONS AND CONTENT |
| DEFSTAN 02-800/2(2015) : 2015 | REQUIREMENTS FOR CALCIUM SILICATE PRODUCTS FOR THERMAL INSULATION |
| DEFSTAN 02-795/2(2016) : 2016 | REQUIREMENTS FOR HEALTH PHYSICS LABORATORIES AND RADIATION FACILITIES IN NUCLEAR SUBMARINES |
| DEFSTAN 83-48/4(2003) : 2003 | CLOTHS, PLAIN WEAVE, COTTON |
| DEFSTAN 59-411(PT5)/1(2007) : 2007 | ELECTROMAGNETIC COMPATIBILITY - PART 5: CODE OF PRACTICE FOR TRI-SERVICE DESIGN AND INSTALLATION |
| IEC 61067-3-1:1995 | Glass and glass polyester fibre woven tapes - Part 3: Specifications for individual materials - Sheet 1: Type 1, 2 and 3 tapes |
| DEFSTAN 02-800/1(2010) : 2010 | REQUIREMENTS FOR CALCIUM SILICATE PRODUCTS FOR THERMAL INSULATIONS |
| DEFSTAN 02-801/1(2010) : 2010 | REQUIREMENTS FOR GLASS FIBRE PRODUCTS FOR USE IN THERMAL INSULATION APPLICATIONS |
| DEFSTAN 59-411(PT4)/1(2007) : 2007 | ELECTROMAGNETIC COMPATIBILITY - PART 4: PLATFORM AND SYSTEM TEST AND TRIALS |
| DEFSTAN 07-204(PT1)/1(2000) : 2000 | THE REQUIREMENT FOR FIRE PROTECTION AND DAMAGE CONTROL FOR SURFACE SHIPS - CATEGORY 2 - PART 1: POLICY FOR SURFACE SHIPS |
| DEFSTAN 81-25/4(2006) : 2006 | TAPE, PRESSURE-SENSITIVE ADHESIVE (WATER-RESISTANT FABRIC) |
| BS EN 10088-2:2014 | Stainless steels Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes |
| DEFSTAN 08-113/2(2008) : 2008 | REQUIREMENTS FOR CONSTRAINED LAYER DAMPING (CLD) SYSTEMS ON SURFACE SHIPS & SUBMARINES |
| DEFSTAN 07-247(PT1)/3(2009) : 2009 | THE SELECTION OF MATERIALS ON THE BASIS OF THEIR FIRE CHARACTERISTICS - PART 1: SELECTION OF MATERIALS ON THE BASIS OF THEIR FIRE CHARACTERISTICS |
| BS EN 10027-2:2015 | Designation systems for steels Numerical system |
| DEFSTAN 80-148/3(2004) : 2004 | ADHESIVE, EPOXIDE, GENERAL PURPOSE |
| BS EN 10244-2:2009 | Steel wire and wire products. Non-ferrous metallic coatings on steel wire Zinc or zinc alloy coatings |
| DEFSTAN 02-111/2(2001) : 2001 | REQUIREMENTS FOR THE CONSTRUCTION, FITTING OUT AND TESTING OF REFRIGERATION SPACES IN HM SURFACE SHIPS AND SUBMARINES |
| DEFSTAN 02-803/1(2010) : 2010 | REQUIREMENTS FOR POLYMER FOAMS FOR THERMAL INSULATION |
| DEFSTAN 02-782/2(2010) : 2010 | REQUIREMENTS FOR ADHESIVE FOR MINERAL WOOL MARINE BOARD (MWMB) |
| DEFSTAN 59-411(PT3)/1(2007) : 2007 | ELECTROMAGNETIC COMPATIBILITY - PART 3: TEST METHODS AND LIMITS FOR EQUIPMENT AND SUB SYSTEMS |
| BS EN 61067-3-1:1995 | Glass and glass polyester fibre woven tapes. Specifications for individual materials Type 1, 2 and 3 tapes |
| BS 1449-1.1:1991 | Steel plate, sheet and strip. Carbon and carbon-manganese plate, sheet and strip General specification |
| BS EN 12590:2000 | Textiles. Industrial sewing threads made wholly or partly form synthetic fibres |
| BS EN 573-3:2013 | Aluminium and aluminium alloys. Chemical composition and form of wrought products Chemical composition and form of products |
| DEFSTAN 08-147(PT2)/1(2000) : 2000 | REQUIREMENTS FOR DAMAGE CONTROL AND FIRE PROTECTION FOR THE SAFETY OF SURFACE SHIPS AND SUBMARINES - CATEGORY 1 - PART 2: SUBMARINES |
| DEFSTAN 80-131/1(1989) : 1989 | PAINT, ALUMINIUM, HEAT RESISTING - TYPE: BRUSHING |
| BS EN 515:2017 | Aluminium and aluminium alloys. Wrought products. Temper designations |
| DEFSTAN 59-411(PT2)/1(2007) : 2007 | ELECTROMAGNETIC COMPATIBILITY - PART 2: THE ELECTRIC, MAGNETIC AND ELECTROMAGNETIC ENVIRONMENT |
| BS 3958-6:1972 | Thermal insulating materials Finishing materials; hard setting composition, self-setting cement and gypsum plaster |
| DEFSTAN 02-805/1(2010) : 2010 | REQUIREMENTS FOR VAPOUR BARRIER COATINGS AND PROPRIETARY FLEXIBLE MASTIC SEALERS FOR USE ON INSULATION MATERIALS |
| DEFSTAN 59-411(PT1)/1(2007) : 2007 | ELECTROMAGNETIC COMPATIBILITY - PART 1: MANAGEMENT AND PLANNING |
| DEFSTAN 02-102(PT1)/3(2005) : 2005 | REQUIREMENTS FOR AIR-CONDITIONING AND VENTILATION - PART 1: HM SURFACE SHIPS AND ROYAL FLEET AUXILIARIES |
| DEFSTAN 02-706/2(2010) : 2010 | WELDING & FABRICATION OF SHIP STRUCTURE FOR HM SUBMARINES AND SURFACE SHIPS NOT IN CLASS |
| DEFSTAN 02-802/1(2008) : 2008 | REQUIREMENTS FOR MINERAL WOOL PRODUCTS FOR ACOUSTIC AND THERMAL INSULATION |
| DEFSTAN 02-804/1(2008) : 2008 | REQUIREMENTS FOR CORK PRODUCTS FOR THERMAL INSULATION |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.