DIN EN 10258:1997-07

Foreword
1 Scope
2 Normative references
3 Definitions
4 Designation
5 Condition of delivery
6 Tolerances on thickness
7 Tolerances on width
8 Preferred coil inner diameters
9 Tolerances on length
10 Flatness and edge waviness tolerances
11 Tolerances on out-of-squareness
12 Tolerances on edge camber
13 Ordered format (for cut lengths)
14 Measurement
Annex A (informative) Bibliography

This standard is included in DIN Handbook 28 E. Applies to cold-rolled stainless, heat-resisting and creep resisting steel flat products in thicknesses up to and including 3,0 mm and rolled widths of less than 600 mm delivered as: - narrow strip (coils with a rolled width < 600 mm), - slit cold-rolled narrow strip, - cut lengths obtained from slit cold-rolled narrow strip or cold-cold narrow strip.