DIN EN 13063-3:2007-10

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Shapes, dimensions and tolerances
   4.1 Air-flue system chimney
   4.2 Terminals
   4.3 Pressure-equalising openings
   4.4 Air duct dimensions
5 Requirements
   5.1 General
   5.2 Material requirements for air-flue system
        chimneys and terminals
   5.3 Minimum compressive strength for a
        pressure-equalising opening section
   5.4 Outer wall elements
   5.5 Safety in use
        5.5.1 Thermal resistance
        5.5.2 Thermal resistance of the flue duct
              (concentric)
        5.5.3 Thermal resistance of the flue duct (side by side)
        5.5.4 Thermal resistance of the air duct
   5.6 Resistance to fire external to external
   5.7 Aerodynamic requirements
        5.7.1 Flow resistance of air ducts
        5.7.2 Aerodynamic properties of terminals
        5.7.3 Pressure-equalising opening section
6 Replacement of single components of
   the air flue system chimney
7 Designation
8 Product information
9 Marking and labelling
10 Evaluation of conformity
   10.1 General
   10.2 Initial type testing
   10.3 Evaluation of conformity for the
        exchange of components
   10.4 Factory production control
Annex A (normative) Test methods
         A.1 Compressive strength of pressure-equalising
              opening sections
              A.1.1 Test sample
              A.1.2 Testing equipment
              A.1.3 Test procedure
         A.2 Aerodynamic behaviour of terminals
              under wind conditions
              A.2.1 Test apparatus
              A.2.2 Test sample
              A.2.3 Measuring parameters
              A.2.4 Test procedure
              A.2.5 Test results
Annex ZA (informative) Clauses of this European
         Standard addressing the provisions of the EU
         Construction Products Directive
         ZA.1 Scope and relevant characteristics
         ZA.2 Procedure(s) for attestation of conformity of
              systems chimneys with clay/ceramic flue
              liners
              ZA.2.1 System(s) of attestation of conformity
              ZA.2.2 EC Certificate and Declaration of
                     conformity
         ZA.3 CE marking and labelling
Bibliography

Defines the requirements and test methods for dry (designated D) and/or wet (designated W) air flue system chimneys, including terminals in which the products of combustion are conveyed to the atmosphere through clay/ceramic flue liners and combustion air is conveyed to suitable roomsealed appliances through an air duct or an air gap.