EN 1028-1:2002+A1:2008

Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
   3.1 Pumps and their applications
   3.2 Suction heights
   3.3 Pressures
   3.4 Delivery rates
   3.5 Power
   3.6 Speed of rotation
   3.7 Efficiencies
4 List of significant hazards
5 Safety requirements and/or protective measures
   5.1 General
   5.2 Special requirements
        5.2.1 Mechanical hazards
        5.2.2 Electrical hazards
        5.2.3 Thermal hazards
        5.2.4 Hazards from neglecting ergonomic design principles
        5.2.5 Hazards due to breakdown and/or incorrect installation
               of protection devices
6 General and performance requirements
   6.1 Design
   6.2 Materials
   6.3 Nominal delivery pressure
   6.4 Nominal delivery rate
   6.5 Geodetic nominal suction height
   6.6 Closing pressure
   6.7 Primer
   6.8 Drainability
   6.9 Shut off valves and pump connections
   6.10 Pump inlet screen
   6.11 Low temperature starting
   6.12 Very low temperature behaviour
   6.13 Operating controls
   6.14 Additional equipment
   6.15 Pump integrity protection equipment
   6.16 Efficiency
   6.17 Guarantee points
   6.18 Special tools
7 Verification of the safety requirements and/or protective
   measures
8 Verification of the general and performance requirements
9 Classification and brief designation
10 Designation
11 Information for use
   11.1 General
   11.2 Signals and warning devices
   11.3 Accompanying documents
        11.3.1 General
        11.3.2 Contents
   11.4 Marking
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

This standard applies for centrifugal pumps with priming devices for fire-fighting use supplied separately without driver and couplings. Fire-fighting centrifugal pumps with primer are defined as terminated by their inlet and outlet connec¬tions as well as by their shaft ends.This standard applies for fire-fighting centrifugal pumps with priming devices for use under ambient temperatu¬res between -15 C and 40 C.NOTEFor special conditions, -30 C; see 6.12.This standard does not apply to fire-fighting centrifugal pumps with primer of which the only power source is directly applied manual effort.This standard specifies the classification and general requirements for fire-fighting centrifugal pumps with priming devices with a nominal delivery rate of up to 6000 l/min. This standard deals with significant hazards listed in clause 4, hazardous situations and events during the commis¬sio¬ning, operation and maintenance of fire-fighting centrifugal pumps with priming devices, used as intended and under the conditions foreseen by the manufacturer or the manufacturer's authorized representati¬ve. In addition, fire-fighting centrifugal pumps with priming devices shall conform as appropriate to EN 292 for hazards not covered by this standard.This standard does not deal with the detailed verification of general and safety requirements and/or protective measures. These are covered in EN 1028-2 "Verification of general and safety requirements".