EN 12412-2:2003

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions, symbols, units and subscripts
4 Principle
5 Requirements for test specimen and apparatus
  5.1 General
  5.2 Surround panels
  5.3 Specimen requirements and location
      5.3.1 Complete frames for windows and doors
      5.3.2 Frame and sash, transom or mullion profile sections
  5.4 Calibration panels
  5.5 Temperature measurement and baffle positions
6 Test procedure
  6.1 General
  6.2 Calibration measurements
      6.2.1 General
      6.2.2 Total surface resistance
      6.2.3 Surface resistances and surface coefficients of heat
        transfer
      6.2.4 Surround panel and edge effects
  6.3 Measurement procedure for test specimens
7 Test report
Annex A (normative) Determination of environmental temperature
  A.1 General
  A.2 Environmental temperature
  A.3 Mean radiant temperature
  A.4 Convective surface heat transfer coefficient
Annex B (normative) Linear thermal transmittance of the
        edge zone
Annex C (informative) Example of calibration test and
        measurement of frame specimen
  C.1 Calibration test with panel size 1,23 m x 1,48 m
  C.2 Frame specimen measurement

This European Standard specifies a method, based on EN ISO 8990 and EN ISO 12567-1, to measure the thermal transmittance of frame and sash components of windows and doors, including mullions and transoms.The thermal bridging effect of window or door components (handles, hinges, closing devices, etc.) is included.The test procedure is designed to take into account the whole developed area of the frame or sash surface, but excludes the influence of the thermal bridge introduced through the spacer in sealed glazing units.Edge effects occurring outside of the perimeter of the specimen are excluded. Furthermore, energy transfer due to solar radiation is not taken into account, and air leakage is excluded.The measurements are performed under defined conditions to facilitate the comparison of measured values.Information on the design of the calibration transfer standard is given in EN ISO 12567-1.