EN 50056:1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group I apparatus indicating up to 100 % (v/v) methane in air
01-06-2000
09-07-1998
Foreword
1 Scope
2 Normative reference
3 Definitions
4 General requirements
5 Performance requirements
5.1 General
5.2 Unpowered storage
5.3 Calibration curve (not applicable to alarm-only
apparatus)
5.4 Drift (continuous duty apparatus)
5.5 Drift (spot reading apparatus)
5.6 Alarm
5.7 Temperature
5.8 Pressure
5.9 Humidity
5.10 Air speed
5.11 Pumping rate
5.12 Orientation
5.13 Vibration (applicable only to machine-mounted
apparatus)
5.14 Drop test (applicable to portable apparatus and
remote sensors)
5.15 Warm-up time (not applicable to spot-reading
apparatus)
5.16 Time of response (not applicable to spot-reading
apparatus)
5.17 Minimum time of operation (spot reading apparatus)
5.18 High gas concentrations above the measuring range
5.19 Battery capacity
5.20 Power supply variations
5.21 Power supply interruptions, voltage transients and
step changes of voltage
5.22 Addition of sampling probe
5.23 Dust
5.24 Poisons and other gases
5.25 Electromagnetic immunity
6 Field calibration kit
7 Information for use
This European Standard specifies performance requirements for Group I (as defined in EN 50054) portable, transportable and fixed apparatus for the detection and measurement of methane concentrations in mine air. The apparatus, or parts thereof, are intended for use in mines susceptible to firedamp and shall meet the general requirements and test methods specified in EN 50054. This European Standard is restricted to apparatus intended for the detection and measurement of volume ratios of methane in air from 0 % (v/v) up to 100 % (v/v). NOTE: Apparatus covered by this European Standard will normally be intended to operate in volume ratios greater than 5 % (v/v)
| Committee |
CLC/TC 31
|
| DocumentType |
Standard
|
| PublisherName |
European Committee for Standards - Electrical
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NF EN 50056 : 92 AMD 1 98 | Identical |
| CEI EN 50056 : 2ED 1999 | Identical |
| I.S. EN 50056:1998 | Identical |
| DIN EN 50056 : 1999 | Identical |
| UNE-EN 50056:1999 | Identical |
| VDE 0400-3 : 2015 | Identical |
| NEN EN 50056 : 1998 | Identical |
| NBN EN 50056 : 1998 | Identical |
| BS EN 50056:1999 | Identical |
| BS EN 50054:1999 | Electrical apparatus for the detection and measurement of combustible gases. General requirements and test methods |
| BS EN 50194:2000 | Electrical apparatus for the detection of combustible gases in domestic premises. Test methods and performance requirements |
| I.S. EN 61779-1:2003 | ELECTRICAL APPARATUS FOR THE DETECTION AND MEASUREMENT OF FLAMMABLE GASES - PART 1: GENERAL REQUIREMENTS AND TEST METHODS |
| EN 50054:1998 | Electrical apparatus for the detection and measurement of combustible gases - General requirements and test methods |
| PREN 50134-2 : DRAFT 2016 | ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES |
| CSA PLUS 2203 : 2001 | HAZARDOUS LOCATIONS - GUIDE FOR THE DESIGN, TESTING, CONSTRUCTION, AND INSTALLATION OF EQUIPMENT IN EXPLOSIVE ATMOSPHERES |
| ISA 12.13.01 : 2003 | PERFORMANCE REQUIREMENTS FOR COMBUSTIBLE GAS DETECTORS |
| CEI UNI EN 50194 : 2001 | ELECTRICAL APPARATUS FOR THE DETECTION OF COMBUSTIBLE GASES IN DOMESTIC PREMISES - TEST METHODS AND PERFORMANCE REQUIREMENTS |
| DIN EN 50134-2 : 2000 | ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES |
| VDE 0400-40-1 : 2000 AMD 1 2004 | SPECIFICATION FOR OPEN PATH APPARATUS FOR THE DETECTION OF COMBUSTIBLE OR TOXIC GASES AND VAPOURS - PART 1: GENERAL REQUIREMENTS AND TEST METHODS |
| DIN EN 50241-1 : 2000 AMD 1 2004 | SPECIFICATION FOR OPEN PATH APPARATUS FOR THE DETECTION OF COMBUSTIBLE OR TOXIC GASES AND VAPOURS - PART 1: GENERAL REQUIREMENTS AND TEST METHODS |
| BS EN 50241-1:1999 | Specification for open path apparatus for the detection of combustible or toxic gases and vapours General requirements and test methods |
| 04/30112677 DC : 0 | IEC 61779-1 ED.2 - ELECTRICAL APPARATUS FOR THE DETECTION AND MEASUREMENT OF FLAMMABLE GASES - PART 1: GENERAL REQUIREMENTS AND TEST METHODS |
| VDE 0830-4-2 : 2000 | ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES |
| EN 50241-1 : 99 AMD 1 2004 | SPECIFICATION FOR OPEN PATH APPARATUS FOR THE DETECTION OF COMBUSTIBLE OR TOXIC GASES AND VAPOURS - PART 1: GENERAL REQUIREMENTS AND TEST METHODS |
| EN 1532:1997 | Installation and equipment for liquefied natural gas - Ship to shore interface |
| I.S. EN 1532:1997 | INSTALLATION AND EQUIPMENT FOR LIQUEFIED NATURAL GAS - SHIP TO SHORE INTERFACE |
| 16/30331025 DC : 0 | BS EN 50134-2 - ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES |
| CEI EN 50134-2 : 2000 | ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES |
| I.S. EN 50241-1:1999 | SPECIFICATION FOR OPEN PATH APPARATUS FOR THE DETECTION OF COMBUSTIBLE OR TOXIC GASES AND VAPOURS - GENERAL REQUIREMENTS AND TEST METHODS |
| EN 50194:2000 | Electrical apparatus for the detection of combustible gases in domestic premises - Part 1: Test methods and performance requirements |
| ISA 12.13.0 : *DUPLICATE RECORD* | **DUPLICATE RECORD** |
| EN 50054:1998 | Electrical apparatus for the detection and measurement of combustible gases - General requirements and test methods |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.