EN IEC 61010-2-120:2018

FOREWORD
INTRODUCTION
1 Scope and object
2 Normative references
3 Terms and definitions
4 Tests
5 Marking and documentation
6 Protection against electric shock
7 Protection against mechanical HAZARDS
8 Resistance to mechanical stresses
9 Protection against the spread of fire
10 Equipment temperature limits and resistance to heat
11 Protection against HAZARDS from fluids
12 Protection against radiation, including laser sources,
    against sonic and ultrasonic pressure and vibrations
13 Protection against liberated gases and substances,
    explosion and implosion
14 Components and subassemblies
15 Protection by interlocks
16 HAZARDS resulting from application
17 RISK assessment
101 Requirements for CONTROL SYSTEMs and
    devices related to safety
102 Operating conditions of equipment
103 Protection against HAZARDS during maintenance
    and service
Annex J (informative) - RISK assessment
Annex L (informative) - Index of defined terms
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding
         European publications

IEC 61010-2-120:2016 specifies particular safety requirements for the following types of electrical equipment and their accessories, wherever they are intended to be used, which fall under a), b), or c) below and present HAZARDS from the power driven moving parts according to one or more of the items 1) to 5) used by the equipment for a specific application.

1) An assembly, fitted with or intended to be fitted with a drive system other than directly applied human or animal effort, consisting of linked parts or components, at least one of which moves, and which are joined together for a specific application.

2) An assembly referred to in item 1), missing only the components to connect it on site or to sources of energy and motion.

3) An assembly referred to in items 1) and 2), ready to be installed and able to function as it stands only if mounted on a means of transport, or installed in a building or a structure.

4) Assemblies referred to in items 1), 2) and 3) or partly completed assemblies which, in order to achieve the same end, are arranged and controlled so that they function as an integral whole. A partly completed assembly is equipment which cannot perform a specific application by itself. A partly completed assembly is only intended to be incorporated into, or assembled with, other equipment, thereby forming equipment to which this standard applies.

5) An assembly of linked parts or components, at least one of which moves and which are joined together, intended for lifting loads and whose only power source is directly applied human effort.


This publication is to be read in conjunction with IEC 61010-1:2010.
It has the status of a group safety publication in accordance with IEC Guide 104