I.S. EN 60068-2-6:2008

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements for testing
   4.1 Required characteristics
       4.1.1 Basic motion
       4.1.2 Spurious motion
       4.1.3 Signal tolerance
       4.1.4 Vibration amplitude tolerances
       4.1.5 Frequency tolerances
       4.1.6 Sweep
   4.2 Control strategy
       4.2.1 Single/multipoint control
       4.2.2 Multi-reference control
   4.3 Mounting
5 Severities
   5.1 Frequency range
       5.1.1 Lower frequency f[1] Hz
       5.1.2 Upper frequency f[2] Hz
   5.2 Vibration amplitude
   5.3 Duration of endurance
       5.3.1 Endurance by sweeping
       5.3.2 Endurance at fixed frequencies
6 Preconditioning
7 Initial measurements
8 Testing
   8.1 General
   8.2 Vibration response investigation
   8.3 Endurance procedures
       8.3.1 Endurance by sweeping
       8.3.2 Endurance at fixed frequencies
9 Intermediate measurements
10 Recovery
11 Final measurements
12 Information to be given in the relevant specification
13 Information to be given in the test report
Annex A (informative) Guide to test Fc
Annex B (informative) Examples of severities primarily intended
                      for components
Annex C (informative) Examples of severities primarily intended
                      for equipment
Annex ZA (normative) Normative references to international
                     publications with their corresponding European
                     publications
Bibliography

Gives a method of test that provides a standard procedure to determine the ability of components, equipment and other articles, to withstand specified severities of sinusoidal vibration.