Skip to content
Please enter a keyword to search
  • Preview

    I.S. EN 60317-0-1:2014

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0-1: GENERAL REQUIREMENTS - ENAMELLED ROUND COPPER WIRE

    Available format(s):  Hardcopy, PDF

    Superseded date:  14-11-2019

    Language(s):  English

    Published date:  01-01-2014

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 Scope
    2 Normative references
    3 Terms, definitions, general notes and appearance
    4 Dimensions
    5 Electrical resistance
    6 Elongation
    7 Springiness
    8 Flexibility and adherence
    9 Heat shock
    10 Cut-through
    11 Resistance to abrasion
    12 Resistance to solvents
    13 Breakdown voltage
    14 Continuity of insulation (nominal conductor diameters
       up to and including 1,600 mm)
    15 Temperature index
    16 Resistance to refrigerants
    17 Solderability
    18 Heat or solvent bonding
    19 Dielectric dissipation factor
    20 Resistance to transformer oil

    21 Loss of mass
    23 Pin hole test
    30 Packaging
    Annex A (informative) - Dimensions for intermediate nominal
            conductor diameters (R 40)
    Annex B (informative) - Method for the calculation of linear
            resistance
    Annex C (informative) - Resistance
    Bibliography
    Annex ZA (normative) - Normative references to international
             Publications with their corresponding
             European publications

    Abstract - (Show below) - (Hide below)

    Defines general requirements of enamelled round copper winding wires with or without bonding layer.

    General Product Information - (Show below) - (Hide below)

    Development Note For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO 3:1973 Preferred numbers Series of preferred numbers
    IEC 60172:2015 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires
    EN 60172:2015 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective