I.S. EN 60495:1994
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SINGLE SIDEBAND POWER-LINE CARRIER TERMINALS
Hardcopy , PDF
06-03-2013
English
01-01-1994
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
FOREWORD
INTRODUCTION
1 General
1.1 Scope and object
1.2 Normative references
2 Definitions
2.1 General
2.2 Frequency bands
2.3 Nominal impedance
2.4 Carrier-frequency output power
2.5 Spurious emissions
3 Operating conditions
3.1 Temperature and humidity
3.2 Power supply
4 Storage and transportation conditions
4.1 Storage conditions
4.2 Transportation conditions
5 Requirements for input and output quantities of PLC terminals
5.1 General
5.2 Carrier-frequency side
5.3 Voice-frequency side
Figures
Annexes
A - Particular recommendations for multichannel terminals
B - Definitions
C - Climatic conditions - operation
D - Climatic conditions - storage
ANNEX ZA (normative) OTHER INTERNATIONAL PUBLICATIONS QUOTED
IN THIS STANDARD WITH THE REFERENCES OF THE RELEVANT
EUROPEAN PUBLICATIONS
Applies to Single Sideband (SSB) Power Line Carrier (PLC) Terminals used to transmit information over High Voltage (HV) Lines.
| DocumentType |
Standard
|
| Pages |
84
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| NF EN 60495 : 1994 | Identical |
| IEC 60495:1993 | Identical |
| DIN EN 60495 : 1995 | Identical |
| UNE-EN 60495:1996 | Identical |
| SN EN 60495 : 1994 | Identical |
| BS EN 60495:1994 | Identical |
| NBN EN 60495 : 1996 | Identical |
| EN 60495:1994 | Identical |
| IEC 60255-22-1:2007 | Measuring relays and protection equipment - Part 22-1: Electrical disturbance tests - 1 MHz burst immunity tests |
| IEC 60038:2009 | IEC standard voltages |
| IEC TR 60663:1980 | Planning of (single-sideband) power line carrier systems |
| EN 60721-3-1:1997 | Classification of environmental conditions - Part 3: Classification of groups of environmental parameters and their severities - Section 1: Storage |
| IEC 60050-151:2001 | International Electrotechnical Vocabulary (IEV) - Part 151: Electrical and magnetic devices |
| IEC 60801-4:1988 | Electromagnetic compatibility for industrial-process measurement and control equipment - Part 4: Electrical fast transient/burst requirements |
| HD 472 S1:1989/AC:2013 | NOMINAL VOLTAGES FOR LOW-VOLTAGE PUBLIC ELECTRICITY SUPPLY SYSTEMS |
| IEC 60050-55:1970 | International Electrotechnical Vocabulary (IEV) - Part 55: Telegraphy and telephony |
| IEC 60721-3-2:1997 | Classification of environmental conditions - Part 3: Classification of groups of environmental parameters and their severities - Section 2: Transportation |
| IEC 60255-5:2000 | Electrical Relays - Part 5: Insulation coordination for measuring relays and protection equipment - Requirements and tests |
| IEC 60801-3:1984 | Electromagnetic compatibility for industrial-process measurement and control equipment - Part 3: Radiated electromagnetic field requirements |
| IEC 60721-3-3:1994+AMD1:1995+AMD2:1996 CSV | Classification of environmental conditions - Part 3-3: Classification of groups of environmental parameters and their severities - Stationary use at weatherprotected locations |
| EN 60721-3-2:1997 | Classification of environmental conditions - Part 3: Classification of groups of environmental parameters and their severities - Section 2: Transportation |
| HD 543.1 : 200S1 | PERFORMANCE AND TESTING OF TELEPROTECTION EQUIPMENT OF POWER SYSTEMS - NARROW-BAND COMMAND SYSTEMS |
| HD 481.3 : 200S1 | ELECTROMAGNETIC COMPATIBILITY FOR INDUSTRIAL-PROCESS MEASUREMENT AND CONTROL EQUIPMENT - RADIATED ELECTROMAGNETIC FIELD REQUIREMENTS |
| EN 60721-3-4:1995/A1:1997 | CLASSIFICATION OF ENVIRONMENTAL CONDITIONS - PART 3: CLASSIFICATION OF GROUPS OF ENVIRONMENTAL PARAMETERS AND THEIR SEVERITIES - SECTION 4: STATIONARY USE AT NON-WEATHER-PROTECTED LOCATIONS |
| IEC 60801-2:1991 | Electromagnetic compatibility for industrial-process measurement and control equipment - Part 2: Electrostatic discharge requirements |
| EN 60801-2 : 1993 | ELECTROMAGNETIC COMPATIBILITY FOR INDUSTRIAL-PROCESS MEASUREMENT AND CONTROL EQUIPMENT - PART 2: ELECTROSTATIC DISCHARGE REQUIREMENTS (IEC 801-2:1991) |
| IEC 60721-3-1:1997 | Classification of environmental conditions - Part 3 Classification of groups of environmental parameters and their severities - Section 1: Storage |
| IEC 60834-1:1999 | Teleprotection equipment of power systems - Performance and testing - Part 1: Command systems |
| EN 60721-3-3 : 95 AMD 2 97 | CLASSIFICATION OF ENVIRONMENTAL CONDITIONS - CLASSIFICATION OF GROUPS OF ENVIRONMENTAL PARAMETERS AND THEIR SEVERITIES - STATIONARY USE AT WEATHER-PROTECTED LOCATIONS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.