I.S. EN 61347-2-1:2004

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Heating of built-in and independent starting devices
16 Pulse voltage of ignitors
17 Mechanical strength
18 Construction
19 Creepage distances and clearances
20 Screws, current-carrying parts and connections
21 Resistance to heat, fire and tracking
22 Resistance to corrosion
Annex A (normative) - Test to establish whether a conductive
        part is a live part which may cause an electric shock
Annex B (normative) - Particular requirements for thermally
        protected lamp controlgear
Annex C (normative) - Particular requirements for electronic
        lamp controlgear with means of protection against
        overheating
Annex D (normative) - Requirements for carrying out the
        heating tests of thermally protected lamp
        controlgear
Annex E (normative) - Use of constant S other than 4500 in t[w]
        tests
Annex F (normative) - Draught-proof enclosure
Annex G (informative) - Explanation of the derivation of the
        values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Mechanical strength testing
Annex J (normative) - Precautions to be observed when measuring
        with sphere-gaps
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

Describes particular safety requirements for starting devices (starters other than glow starters and ignitors) for fluorescent and other discharge lamps.