FOREWORD
1 General
1.1 Scope
1.2 Object
1.3 Normative references
1.4 Information to be given in a detail specification
1.5 Terminology
1.6 Marking
2 Preferred rating and characteristics
2.1 Preferred characteristics
2.2 Preferred values of ratings
3 Quality assessment procedures
3.1 Primary stage of manufacture
3.2 Structurally similar components
3.3 Declaration of conformity (basic requirements)
3.4 Test schedule and requirement for initial assessment
(mandatory and optional tests)
3.5 Quality conformance inspection
4 Test and measurement procedures
4.1 Preliminary drying
4.2 Measuring conditions
4.3 Visual examination and check of dimensions
4.4 Electrical tests
4.5 Robustness of terminations
4.6 Resistance to soldering heat
4.7 Solderability
4.8 Rapid change of temperature
4.9 Vibration
4.10 Endurance
4.11 Self-discharge
4.12 Storage at high temperature
4.13 Characteristics at high and low temperature
4.14 Damp heat, steady state
4.15 Passive flammability (if applicable)
4.16 Pressure relief (if applicable)
Annex A (informative) Calculation procedure for power density
Annex ZA (normative) Normative references to international
publications with their corresponding European publications