NS EN 1845 : 2ED 2007

Foreword
0 Introduction
1 Scope
2 Normative references
3 Definitions
4 List of hazards
5 Safety requirements and/or measures
6 Verification of safety requirements and/or measures
7 Information for use
Annex A (normative) Guards
Annex B (normative) Interlocking systems
Annex C (normative) Trip devices
Annex D (normative) Two-hand control devices
Annex E (normative) Hold-to-run control device
Annex F (normative) Pressure sensitive devices (mats
                      or floors)
Annex G (normative) Power interlocking system
Annex H (normative) Two-fault safety of machine control
                      systems
Annex J (informative) Minimum temperatures of burn
                        threshold (see EN 563:1994)
Annex K (normative) Working and measurement conditions
                      for noise determination
Annex L (informative) Important considerations and
                        requirements of prEN 1921:1995
Annex ZA (informative) Relationship of this European
                         Standard with EU Directives

Applicable to footwear moulding machines which are intended for use in the shoe industry for the production of footwear and footwear components. These machines are; full shoe and boot moulding machines, unit sole and footwear component moulding machines, direct-on sole moulding machines. Specifies safety requirements for transport, installation, construction, adjustment, setting, teaching or process change-over, cleaning, operation, decommissioning, maintenance, dismantling and, as far as safety is concerned, disposal for machines.