PD CEN/TR 15840:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 Specific definitions
  3.2 General definitions
4 Tasks for the producer
  4.1 Factory production control
  4.2 Internal quality control
  4.3 Autocontrol testing of samples
5 Tasks fro the certification body
  5.1 General
  5.2 Surveillance, assessment and acceptance of the
      production control
  5.3 Evaluation of the results of autocontrol testing of
      samples
  5.4 Audit testing of samples taken at the production
      plant/depot and initial type testing
  5.5 Initial inspection of the production plant and the
      production control
  5.6 Evaluation of test results during the initial period
6 Actions in the event of non-conformity
  6.1 Actions to be taken by the producer
  6.2 Actions to be taken by the certification body
7 Procedure for third party certification of conformity
8 Certificate of conformity and conformity mark
  8.1 Indication of conformity
  8.2 Certificate of conformity
  8.3 Conformity mark
9 Requirements for dispatching centres
  9.1 General requirements
  9.2 Tasks for the intermediary
  9.3 Tasks for the third party
Annex A (normative) - Evaluation of the representativeness
                      and the accuracy of the fineness test
                      results
      A.1 General
      A.2 Sets of results considered
      A.3 Evaluation procedure
Annex B (informative) - General definitions
      B.1 Definitions based on the Construction Products
          Directive
      B.2 Definitions from or based on EN 45020
      B.3 Definition from EN ISO 9000
      B.4 Definitions from EN 197-1 and EN 196-7
Bibliography

Describes the scheme for the evaluation of conformity of fly ash according to EN 450-1:2005.