PD ISO/TS 11619:2014
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Polyurethane tubing for use primarily in pneumatic installations. Dimensions and specification
Hardcopy , PDF
25-07-2024
English
28-02-2014
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Materials and construction
5 Dimensions and tolerances
6 Performance requirements
7 Type, routine and production testing
8 Marking
9 Recommendations for packing and storage
Annex A (normative) - Test frequency
Annex B (informative) - Recommended tests
for production testing
Bibliography
Defines the requirements for flexible thermoplastic polyurethane tubing conveying compressed air, for use in the ambient temperature range from 23 degrees C to 60 degrees C, in sizes from 3 mm to 12 mm outside diameter.
| Committee |
PRI/66
|
| DocumentType |
Standard
|
| Pages |
18
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
This Technical Specification specifies the requirements for flexible thermoplastic polyurethane tubing conveying compressed air, for use in the ambient temperature range from 23°C to 60°C, in sizes from 3mm to 12mm outside diameter. Working pressure depends on the tube size and the service temperature (see Table4). Tubing may be used with push on connectors which are specified in ISO14743.
| Standards | Relationship |
| ISO/TS 11619:2014 | Identical |
| ISO 8331:2016 | Rubber and plastics hoses and hose assemblies Guidelines for selection, storage, use and maintenance |
| ISO 8330:2007 | Rubber and plastics hoses and hose assemblies Vocabulary |
| ISO 10619-1:2011 | Rubber and plastics hoses and tubing Measurement of flexibility and stiffness Part 1: Bending tests at ambient temperature |
| ISO 14743:2004 | Pneumatic fluid power Push-in connectors for thermoplastic tubes |
| ISO 1402:2009 | Rubber and plastics hoses and hose assemblies Hydrostatic testing |
| ISO 1307:2006 | Rubber and plastics hoses — Hose sizes, minimum and maximum inside diameters, and tolerances on cut-to-length hoses |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.