SN EN 60094-1 : 1993 AMD 1 1994

Cooperating organizations
National foreword
Foreword
Section one - General
1 Scope
2 Definitions
3 Units and symbols
4 Drawing office practice
5 Scales for graphical presentation of data
6 Mechanical and electrical matching requirements
7 High fidelity equipment and systems
8 Flammability
Section two - Mechanical requirements
9 Tape dimensions
10 Tape speed
11 Direction of tape winding
12 Mechanical requirements and dimensions and recording
    systems according to tape carrier
13 Designation of magnetic tracks
14 Allocation and dimensions of magnetic tracks
    according to tape carrier
Section three - Electrical requirements
15 Amplitude/frequency response of the recorded short-
    circuit flux
16 Reproducing electrical amplitude/frequency response
17 Tolerances on recording and reproducing system
    characteristics
Section four - Tape and programme identification
18 Identification of tape sides
19 Programme identification
20 Colour of leader tapes, reel-to-reel systems
Appendix
A Explanation of the drawing system used in the
    different parts of IEC Publications 94
Annex
ZA Other international publications quoted in this
    standard with the references of the relevant
    European publications
National annex NA (informative) Committees responsible
National annex NB (informative) Cross-references

ALSO NUMBERED AS BS 6288: PART 1: 1994. Applies to the dimensional, mechanical and electrical requirements for non-perforated blank and pre-recorded magnetic tape and for the associated recording and reproducing systems such as reel-to-reel, cassette and cartridge. Coverage includes definitions, flammability, tape speed, and scales for graphical presentation of data.