SN EN 60928 : 1995 AMD 1 1999

Committees responsible
National foreword
Foreword
Section 1. General requirements
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
Section 2. Safety requirements
8 Terminals
9 Provision for earthing
10 Creepage distances and clearances
11 Protection against accidental contact with live parts
12 Protection of associated components
13 Moisture resistance and insulation
14 Electric strength
15 Abnormal conditions
16 Fault conditions
17 Screws, current-carrying parts and connections
18 Resistance to heat and fire
19 Resistance to corrosion
Figures
Annex A (normative) Test to establish whether a
         conductive part is a live part which may cause an
         electric shock
Annex B (normative) Particular requirements for
         electronic ballasts with means of protection
         against overheating
Annex C (normative) Particular additional safety
         requirements for a.c./d.c. supplied electronic
         ballasts for maintained emergency lighting
Annex D (normative) Measurement of high-frequency
         leakage current
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

Describes general and safety requirements for electronic ballasts for use on a.c. supplies up to 1,000V at 50 Hz or 60 Hz with operating frequencies deviating from supply frequency, associated with tubular fluorescent lamps as described in IEC publication 81 and other tubular fluorescent lamps for high-frequency operation. Special requirements for electronic ballasts with protective devices against overheating are included.