UNI EN 10143 : 2006

Cooperating organizations
National foreword
Foreword
1 Scope
2 Normative references
3 Definitions
4 Designation
5 Condition of delivery
6 Tolerances on dimensions and shapes
6.1 Thickness
6.2 Width
6.3 Length
6.4 Flatness
6.5 Out-of-squareness
6.6 Edge camber
6.7 Superimposement of dimensions
7 Measurement
7.1 Thickness
7.2 Width
7.3 Length
7.4 Flatness
7.5 Out-of-squareness
7.6 Edge camber
National annex NA (informative) Committees responsible
National annex NB (informative) Cross-references
National annex NC (normative) Tolerances on dimensions
and shape for material over 3 mm thick

This European Standard applies to continuously zinc (Z), zinc-iron alloy (ZF), zinc-aluminium alloy (ZA), aluminium-zinc alloy (AZ) and aluminium- silicon alloy (AS) hot-dip coated flat products made of low carbon and high strength steels for cold forming and of structural steels with a minimum thickness of 0,20 mm and a maximum thickness of 6,50 mm, delivered as sheet, wide strip, slit wide strip or cut lengths obtained from slit wide strip or sheet.