UNI EN 755-1 : 2008

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Ordering information
5 Requirements
   5.1 Production and manufacturing processes
   5.2 Quality control
   5.3 Chemical composition limits
   5.4 Mechanical properties
   5.5 Freedom from surface defects
   5.6 Tolerances on dimensions and form
   5.7 Stress corrosion cracking resistance
   5.8 Additional requirements
6 Test procedures
   6.1 Sampling
   6.2 Test methods
   6.3 Re-tests
7 Inspection documents
8 Marking of products
9 Packaging
10 Arbitration
Annex A (normative) - Location of test pieces
      A.1 Round, square and hexagonal bar
          A.1.1 For diameter (D) or width across flats (S)
                up to and including 40 mm:
          A.1.2 For diameter (D) or width across flats (S)
                over 40 mm;
      A.2 Rectangular bar
          A.2.1 For thickness up to and including 12,5 mm:
          A.2.2 For thickness (T) over 12,5 mm and up to and
                including 40 mm:
          A.2.3 For thickness (T) exceeding 40 mm:
      A.3 Tube
      A.4 Profiles
          A.4.1 For thickness up to and including 12,5 mm:
          A.4.2 For thickness over 12,5 mm and up to and
                including 40 mm:
          A.4.3 For thickness exceeding 40 mm:
Annex B (normative) - Resistance to stress-corrosion cracking
        for alloy EN AW-7075 in tempers T73, T73510 and
        T73511 - Electrical conductivity
Bibliography

Describes the technical conditions for inspection and delivery of wrought aluminium and aluminium alloy extruded rod/bar, tube and profile for general engineering applications.