• 14/30295204 DC : 0

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    BS 7629-1 - ELECTRIC CABLES - SPECIFICATION FOR 300/500 V FIRE RESISTANT SCREENED CABLES HAVING LOW EMISSION OF SMOKE AND CORROSIVE GASES WHEN AFFECTED BY FIRE FOR FIXED INSTALLATIONS - PART 1: MULTICORE CABLES

    Available format(s):  Hardcopy, PDF

    Superseded date:  31-08-2015

    Language(s):  English

    Published date: 

    Publisher:  British Standards Institution

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Voltage designation and fire rated categories
    5 Conductors and drain wire
    6 Insulation
    7 Identification of cores
    8 Laying up
    9 Screen
    10 Sheath
    11 Cable marking and additional information
    12 Schedule of tests
    13 Test conditions
    14 Routine tests
    15 Sample tests
    16 Type tests
    Annexes
    Annex A (informative) - Guide to use
    Annex B (normative) - Method of test for continuity of
            tinned coatings of wires
    Annex C (normative) - Method of test for voltage
            withstand
    Annex D (normative) - Method of test for bending
            characteristics
    Annex E (normative) - Method of test for resistance to impact
    Annex F (normative) Method of test for shrinkage of sheath
            on cable during heat treatment
    Annex G (informative) Notes on type tests
    Bibliography

    General Product Information - (Show below) - (Hide below)

    Comment Closes On
    Committee GEL/20/17
    Document Type Draft
    Publisher British Standards Institution
    Status Superseded

    Standards Referencing This Book - (Show below) - (Hide below)

    BS EN 60811-506:2012 Electric and optical fibre cables. Test methods for non-metallic materials Mechanical tests. Impact test at low temperature for insulations and sheaths
    BS EN 61034-2 : 2005 MEASUREMENT OF SMOKE DENSITY OF CABLES BURNING UNDER DEFINED CONDITIONS PART 2: TEST PROCEDURE AND REQUIREMENTS
    BS 5266-1:2011 Emergency lighting Code of practice for the emergency escape lighting of premises
    BS EN 60811-502:2012 Electric and optical fibre cables. Test methods for non-metallic materials Mechanical tests. Shrinkage test for insulations
    BS EN 50200:2015 Method of test for resistance to fire of unprotected small cables for use in emergency circuits
    BS EN 61034-1 : 2005 MEASUREMENT OF SMOKE DENSITY OF CABLES BURNING UNDER DEFINED CONDITIONS - PART 1: TEST APPARATUS
    BS 5839-1:2013 Fire detection and fire alarm systems for buildings Code of practice for design, installation, commissioning and maintenance of systems in non-domestic premises
    BS EN 60332-1-2 : 2004 TESTS ON ELECTRIC AND OPTICAL FIBRE CABLES UNDER FIRE CONDITIONS - PART 1-2: TEST FOR VERTICAL FLAME PROPAGATION FOR A SINGLE INSULATED WIRE OR CABLE - PROCEDURE FOR 1 KW PRE-MIXED FLAME (IEC 60332-1-2:2004)
    BS EN 50267-2-1:1999 Common test methods for cables under fire conditions. Tests on gases evolved during combustion of materials from cables. Procedures Determination of the amount of halogen acid gas - Determination of the amount of halogen acid gas
    BS EN 60228:2005 Conductors of insulated cables
    BS EN 60079-14:2014 Explosive atmospheres Electrical installations design, selection and erection
    BS 8434-2(2003) : 2003 METHODS OF TEST FOR ASSESSMENT OF THE FIRE INTEGRITY OF ELECTRIC CABLES - PART 2: TEST FOR UNPROTECTED SMALL CABLES FOR USE IN EMERGENCY CIRCUITS - BS EN 50200 WITH A 930 DEGREE C FLAME AND WITH WATER SPRAY
    BS EN 50395 : 2005 ELECTRICAL TEST METHODS FOR LOW VOLTAGE ENERGY CABLES
    BS EN 62230 : 2007 ELECTRIC CABLES - SPARK-TEST METHOD
    IEC 60050-461:2008 International Electrotechnical Vocabulary (IEV) - Part 461: Electric cables
    BS EN 50363-1:2005 Insulating, sheathing and covering materials for low voltage energy cables Cross-linked elastomeric insulating compounds
    BS EN 50363-5 : 2005 INSULATING, SHEATHING AND COVERING MATERIALS FOR LOW VOLTAGE ENERGY CABLES - PART 5: HALOGEN-FREE, CROSS-LINKED INSULATING COMPOUNDS
    BS EN 50396 : 2005 NON ELECTRICAL TEST METHODS FOR LOW VOLTAGE ENERGY CABLES
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective