EN ISO 4064-1:2017
|
Water meters for cold potable water and hot water - Part 1: Metrological and technical requirements (ISO 4064-1:2014) |
EN 12566-1:2016
|
Small wastewater treatment systems for up to 50 PT - Part 1: Prefabricated septic tanks |
EN 12056-2:2000
|
Gravity drainage systems inside buildings - Part 2: Sanitary pipework, layout and calculation |
EN 872:2005
|
Water quality - Determination of suspended solids - Method by filtration through glass fibre filters |
ISO 4064-4:2014
|
Water meters for cold potable water and hot water — Part 4: Non-metrological requirements not covered in ISO 4064-1 |
EN 12056-4:2000
|
Gravity drainage systems inside buildings - Part 4: Wastewater lifting plants - Layout and calculation |
EN 805:2000
|
Water supply - Requirements for systems and components outside buildings |
EN 1717:2000
|
Protection against pollution of potable water in water installations and general requirements of devices to prevent pollution by backflow |
EN 12056-1:2000
|
Gravity drainage systems inside buildings - Part 1: General and performance requirements |
EN 806-3:2006
|
Specifications for installations inside buildings conveying water for human consumption - Part 3: Pipe sizing - Simplified method |
EN 13341:2005+A1:2011
|
Static thermoplastic tanks for above ground storage of domestic heating oils, kerosene and diesel fuels - Blow moulded and rotationally moulded polyethylene tanks and rotationally moulded tanks made of anionically polymerized polyamide 6 - Requirements and test methods |
ISO 4064-5:2014
|
Water meters for cold potable water and hot water — Part 5: Installation requirements |
ISO 4064-3:2014
|
Water meters for cold potable water and hot water — Part 3: Test report format |
ISO 4064-2:2014
|
Water meters for cold potable water and hot water Part 2: Test methods |
EN 16323:2014
|
Glossary of wastewater engineering terms |
EN ISO 4064-2:2017
|
Water meters for cold potable water and hot water - Part 2: Test methods (ISO 4064-2:2014) |
EN 13076:2003
|
Devices to prevent pollution by backflow of potable water - Unrestricted air gap-Family A - Type A |
EN 476:2011
|
General requirements for components used in drains and sewers |
EN 809 : 1998 COR 2010
|
PUMPS AND PUMP UNITS FOR LIQUIDS - COMMON SAFETY REQUIREMENTS |
EN 12566-3:2016
|
Small wastewater treatment systems for up to 50 PT - Part 3: Packaged and/or site assembled domestic wastewater treatment plants |
EN 806-2:2005
|
Specification for installations inside buildings conveying water for human consumption - Part 2: Design |
EN ISO 4064-5:2017
|
Water meters for cold potable water and hot water - Part 5: Installation requirements (ISO 4064-5:2014) |
EN 1610:2015
|
Construction and testing of drains and sewers |
EN 12056-3:2000
|
Gravity drainage systems inside buildings - Part 3: Roof drainage, layout and calculation |
EN 60335-2-41:2003/A2:2010
|
HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES - SAFETY - PART 2-41: PARTICULAR REQUIREMENTS FOR PUMPS |
ISO 4064-1:2014
|
Water meters for cold potable water and hot water Part 1: Metrological and technical requirements |
EN 12056-5:2000
|
Gravity drainage systems inside buildings - Part 5: Installation and testing, instructions for operation, maintenance and use |