ASTM D 5086 : 2001 : R2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Determination of Calcium, Magnesium, Potassium, and Sodium in Atmospheric Wet Deposition by Flame Atomic Absorption Spectrophotometry
Hardcopy , PDF
11-11-2014
English
01-04-2008
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 11.03, 2016 Defines the determination of calcium, magnesium, potassium, and sodium in atmospheric wet deposition (rain, snow, sleet, and hail) by flame atomic absorption spectrophotometry (FAAS).
| Committee |
D 22
|
| DocumentType |
Test Method
|
| Pages |
8
|
| ProductNote |
Reconfirmed 2008
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This test method is applicable to the determination of calcium, magnesium, potassium, and sodium in atmospheric wet deposition (rain, snow, sleet, and hail) by flame atomic absorption spectrophotometry (FAAS). (1)
1.2 The concentration ranges are listed below. The range tested was confirmed using the interlaboratory collaborative test (see Table 1 for a statistical summary of the collaborative test).
| MDL (mg/L) (2) | Range of Method (mg/L) | Range Tested (mg/L) | |
| Calcium | 0.009 | 0.03–3.00 | 0.168–2.939 |
| Magnesium | 0.003 | 0.01–1.00 | 0.039–0.682 |
| Potassium | 0.003 | 0.01–1.00 | 0.029–0.499 |
| Sodium | 0.003 | 0.01–2.00 | 0.105–1.84 |
1.3 The method detection limit (MDL) is based on single operator precision (2) and may be higher or lower for other operators and laboratories. Many workers have found that this test method is reliable at lower levels than were tested, but the precision and bias data presented are insufficient to justify their use at lower levels.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 8.3, 8.7, 12.1.8, and Section 9.
| ASTM D 1129 : 2013 : REDLINE | Standard Terminology Relating to Water |
| ASTM D 2777 : 2013 : REDLINE | Standard Practice for Determination of Precision and Bias of Applicable Test Methods of Committee D19 on Water |
| ASTM D 4691 : 2017 : REDLINE | Standard Practice for Measuring Elements in Water by Flame Atomic Absorption Spectrophotometry |
| ASTM E 275 : 2008 | Describing and Measuring Performance of Ultraviolet and Visible Spectrophotometers |
| ASTM D 4453 : 2017 : REDLINE | Standard Practice for Handling of High Purity Water Samples |
| IEEE/ASTM SI_10-2010 | American National Standard for Metric Practice |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.