BS 7523:1991
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Specification for preformed cellular polyethylene (PE) materials for the thermal insulation of pipework
Hardcopy , PDF
02-01-2024
English
31-10-1991
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Committees responsible
Foreword
Specification
1. Scope
2. Composition
3. Types
4. Dimensions and tolerances
5. Physical properties
6. Condition and appearance
7. Sampling
8. Pipe sections
9. Marking
Appendices
A. Factors affecting the thermal conductivity
B. Method for the determination of thermal
conductivity
C. Burning properties of polyethylene (PE) cellular
materials
D. Notes for designers
Tables
1. Dimensional tolerances for pipe insulation
2. Physical properties
3. Symbols and units
Figures
1. Guarded end apparatus
2. Calibrated or calculated end apparatus
3. Nukiyama correction
Requirements for two types of polyethylene pipe insulation.
| Committee |
B/540
|
| DevelopmentNote |
Supersedes 88/43770 DC. (10/2005) Reviewed and confirmed by BSI, December 2011. (11/2011)
|
| DocumentType |
Standard
|
| Pages |
26
|
| PublisherName |
British Standards Institution
|
| Status |
Withdrawn
|
This British Standard specifies the composition, properties and dimensional tolerances for preformed cellular polyethylene (PE) materials for the thermal insulation of pipework. The nominal operating temperature range for the materials is − 40 °C to + 80 °C (see note 1).
NOTE 1 Manufacturers have experienced no detrimental effects at service temperatures up to 100 °C. Consideration will be given, therefore, to raising the upper service temperature limit at the next revision of this British Standard.
NOTE 2 The titles of the publications referred to in this standard are listed on the inside back cover.
| BS 4840-1:1985 | Rigid polyurethane (PUR) foam in slab form Specification for PUR foam for use in transport containers and insulated vehicle bodies |
| BS 5111-1:1974 | Laboratory methods of test for determination of smoke generation characteristics of cellular plastics and cellular rubber materials Method for testing a 25 mm cube test specimen of low density material (up to 130 kg/m<sup>3</sup>) to continuous flaming conditions |
| BS 2972:1989 | Methods of test for inorganic thermal insulating materials |
| ISO 8497:1994 | Thermal insulation — Determination of steady-state thermal transmission properties of thermal insulation for circular pipes |
| BS 6700:1987 | Specification for design, installation, testing and maintenance of services supplying water for domestic use within buildings and their curtilages |
| BS 4370-2:1973 | Methods of test for rigid cellular materials Methods 6-10 |
| BS 5422:1990 | Method for specifying thermal insulating materials on pipes, ductwork and equipment (in the temperature range -40°C to +700°C) |
| BS 4735:1974 | Laboratory method of test for assessment of the horizontal burning characteristics of specimens no larger than 150 mm x 50 mm x 13 mm (nominal) of cellular plastics and cellular rubber materials when subjected to a small flame |
| BS 6336:1982 | Guide to development and presentation of fire tests and their use in hazard assessment |
| ISO 7345:1987 | Thermal insulation Physical quantities and definitions |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.