![header thumbnail](/images/publishers\bsi_cover.gif)
BS 8110-2:1985
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
![header thumbnail](/images/publishers\bsi_cover.gif)
STRUCTURAL USE OF CONCRETE - PART 2: CODE OF PRACTICE FOR SPECIAL CIRCUMSTANCES
Hardcopy , PDF
16-04-2010
English
01-01-1985
Committees responsible
Foreword
Section 1. General
1.1 Scope
1.2 Definitions
1.3 Symbols
Section 2. Methods of analysis for the ultimate limit
state
2.1 General
2.2 Design loads and strengths
2.3 Non-linear methods
2.4 Torsional resistance of beams
2.5 Effective column height
2.6 Robustness
Section 3. Serviceability conditions
3.1 General
3.2 Serviceability limit states
3.3 Loads
3.4 Analysis of structure for serviceability limit states
3.5 Material properties for the calculation of curvature
and stresses
3.6 Calculation of curvatures
3.7 Calculation of deflection
3.8 Calculation of crack width
Section 4. Fire resistance
4.1 General
4.2 Factors to be considered in determining fire resistance
4.3 Tabulated data (method 1)
4.4 Fire test (method 2)
4.5 Fire engineering calculations (method 3)
Section 5. Additional considerations in the use of
lightweight aggregate concrete
5.1 General
5.2 Cover for durability and fire resistance
5.3 Characteristic strength of concrete
5.4 Shear resistance
5.5 Torsional resistance of beams
5.6 Deflections
5.7 Columns
5.8 Walls
5.9 Anchorage bond and laps
5.10 Bearing stress inside bends
Section 6 (deleted)
Section 7. Elastic deformation, creep, drying shrinkage
and thermal strains of concrete
7.1 General
7.2 Elastic deformation
7.3 Creep
7.4 Drying shrinkage
7.5 Thermal strains
Section 8. Movement joints
8.1 General
8.2 Need for movement joints
8.3 Types of movement joint
8.4 Provision of joints
8.5 Design of joints
Section 9. Appraisal and testing of structures and
components during construction
9.1 General
9.2 Purpose of testing
9.3 Basis of approach
9.4 Check tests on structural concrete
9.5 Load tests of structures or parts of structures
9.6 Load tests on individual precast units
Appendix A Bibliography
Index
Publications referred to
Gives recommendations for the design and construction of structural concrete that arise in special circumstances.
Committee |
CSB/39
|
DevelopmentNote |
Supersedes BS CP110-1(1972). (08/2001) Supersedes 81/15604 DC and 86/12217 DC (10/2005) Supersedes 05/30135244 DC. (12/2005) Reviewed and confirmed by BSI, March 2008. (02/2008) Inactive for the new design. (11/2008)
|
DocumentType |
Standard
|
Pages |
68
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
05/30136143 DC : DRAFT JUL 2005 | BS 5628-2 - CODE OF PRACTICE FOR THE USE OF MASONRY - PART 2: STRUCTURAL USE OF REINFORCED AND PRESTRESSED MASONRY |
ESI 43-4 : ISSUE 2 AMD 1 | DESIGN OF FOUNDATIONS FOR STEEL TOWERS FOR OVERHEAD TRANSMISSION LINES AT 132kV AND HIGHER VOLTAGES |
BS 5061:1974 | Specification for cylindrical forage tower silos and recommendations for their use |
BS 5628-2:1985 | Code of practice for use of masonry Structural use of reinforced and prestressed masonry |
17/30349707 DC : DRAFT AUG 2017 | BS 5975:2018 - CODE OF PRACTICE FOR TEMPORARY WORKS PROCEDURES AND THE PERMISSIBLE STRESS DESIGN OF FALSEWORK |
BS 5911-103:1994 | Precast concrete pipes, fittings and ancillary products Specification for prestressed non-pressure pipes and fittings with flexible joints |
BS 812-120:1989 | Testing aggregates Method for testing and classifying drying shrinkage of aggregates in concrete |
DD ENV 1992-1.1 : DRAFT MAY 1992 | EUROCODE 2: DESIGN OF CONCRETE STRUCTURES - GENERAL RULES FOR BUILDINGS (TOGETHER WITH UNITED KINGDOM NATIONAL APPLICATION DOCUMENT) |
BS 5950-8:1990 | Structural use of steelwork in building Code of practice for fire resistant design |
98/103075 DC : DRAFT APRIL 1998 | CODE OF PRACTICE FOR MACHINE LAID IN SITU EDGE DETAILS FOR PAVED AREAS |
BS 6374-5:1985 | Lining of equipment with polymeric materials for the process industries Specification for lining with rubbers |
BS 6229:2003 | Flat roofs with continuously supported coverings. Code of practice |
BS 5975(2008) : 2008 | CODE OF PRACTICE FOR TEMPORARY WORKS PROCEDURES AND THE PERMISSIBLE STRESS DESIGN OF FALSEWORK |
BS 6349-2:1988 | Maritime structures Design of quay walls, jetties and dolphins |
BS 8297:2000 | Code of practice for Design and installation of non-loadbearing precast concrete cladding |
BS 5911-3:2002 | Concrete pipes and ancillary concrete products Specification for unreinforced and reinforced concrete manholes and soakaways (complementary to BS EN 1917:2002) |
BS 8202-1:1995 | Coatings for fire protection of building elements Code of practice for the selection and installation of sprayed mineral coatings |
07/30160560 DC : DRAFT JAN 2007 | PD 5500 AMD 2 - SPECIFICATION FOR UNFIRED FUSION WELDED PRESSURE VESSELS |
BS 6349-3:1988 | Maritime structures Design of dry docks, locks, slipways and shipbuilding berths, shiplifts and dock and lock gates |
BS 7361-1:1991 | Cathodic protection Code of practice for land and marine applications |
BS 5911-4(2002) : 2002 | CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 4: SPECIFICATION FOR UNREINFORCED AND REINFORCED CONCRETE INSPECTION CHAMBERS |
BS 5628-2:1995 | Code of practice for use of masonry Structural use of reinforced and prestressed masonry |
BS 5628-2:2000 | Code of practice for use of masonry Structural use of reinforced and prestressed masonry |
BS 5628-2:2005 | CODE OF PRACTICE FOR THE USE OF MASONRY - PART 2: STRUCTURAL USE OF REINFORCED AND PRESTRESSED MASONRY |
BS 1217:1997 | Specification for cast stone |
BS 6180:1999 | Barriers in and about buildings. Code of practice |
BS 6349-4:1994 | Maritime structures Code of practice for design of fendering and mooring systems |
BS 5950-2:1992 | Structural use of steelwork in building Specification for materials, fabrication and erection: hot-rolled sections |
PD 5500:2003 | Specification for unfired fusion welded pressure vessels |
BS PAS 68(2007) : 2007 | SPECIFICATION FOR VEHICLE SECURITY BARRIERS |
BS 4076:1989 | Specification for steel chimneys |
BS 5911-200:1994 | Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced manholes and soakaways of circular cross section |
BS PD5500(2006) : 2006 | SPECIFICATION FOR UNFIRED FUSION WELDED PRESSURE VESSELS |
BS 5628-1:2005 | Code of practice for the use of masonry Structural use of unreinforced masonry |
BS 5950-1:2000 | Structural use of steelwork in building Code of practice for design. Rolled and welded sections |
BS 8110-1:1997 | Structural use of concrete Code of practice for design and construction |
BS 6180:1995 | Code of practice for barriers in and about buildings |
BS PAS 68(2010) : 2010 | IMPACT TEST SPECIFICATIONS FOR VEHICLE SECURITY BARRIERS |
BS 4485-4:1996 | Water cooling towers Code of practice for structural design and construction |
BS 7777-3:1993 | Flat-bottomed, vertical, cylindrical storage tanks for low temperature service Recommendations for the design and construction of prestressed and reinforced concrete tanks and tank foundations, and for the design and installation of tank insulation, tank liners and tank coatings |
09/30209209 DC : 0 | BS 5911-3 - CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 3: SPECIFICATION FOR UNREINFORCED AND REINFORCED CONCRETE MANHOLES AND SOAKAWAYS (COMPLEMENTARY TO BS EN 1917:2002) |
BS 6349-6:1989 | Maritime structures Design of inshore moorings and floating structures |
BS 5911-100:1988 | Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced pipes and fittings with flexible joints |
ENA TS 43-4 : ISSUE 2 AMD 1 1993 | DESIGN OF FOUNDATIONS FOR STEEL TOWERS FOR OVERHEAD TRANSMISSION LINES AT 132 KV AND HIGHER VOLTAGES |
BS 8110-1:1985 | Structural use of concrete Code of practice for design and construction |
BS 7777-1:1993 | Flat-bottomed, vertical, cylindrical storage tanks for low temperature service Guide to the general provisions applying for design, construction, installation and operation |
BS 8002:1994 | Code of practice for earth retaining structures |
BS 5493:1977 | Code of practice for protective coating of iron and steel structures against corrosion |
BS 8000-2.1:1990 | Workmanship on building sites. Code of practice for concrete work Mixing and transporting concrete |
PD 7974-3:2003 | Application of fire safety engineering principles to the design of buildings Structural response and fire spread beyond the enclosure of origin (Sub-system 3) |
BS 8202-1:1987 | Coatings for fire protection of building elements Code of practice for the selection and installation of sprayed mineral coatings |
BS 8110-3(1985) : 1985 | STRUCTURAL USE OF CONCRETE - PART 3: DESIGN CHARTS FOR SINGLY REINFORCED BEAMS, DOUBLY REINFORCED BEAMS AND RECTANGULAR COLUMNS |
07/30150912 DC : 0 | BS 5975 - CODE OF PRACTICE FOR THE PROCEDURAL CONTROL OF TEMPORARY WORKS AND THE PERMISSIBLE STRESS DESIGN OF FALSEWORK |
BS 8208-1:1985 | Guide to assessment of suitability of external cavity walls for filling with thermal insulants Existing traditional cavity construction |
BS 8200:1985 | Code of practice for design of non-loadbearing external vertical enclosures of buildings |
09/30201029 DC : DRAFT MAY 2009 | BS 6089 - ASSESSMENT OF IN-SITU COMPRESSIVE STRENGTH IN STRUCTURES AND PRECAST CONCRETE COMPONENTS - COMPLEMENTARY GUIDANCE TO THAT GIVEN IN BS EN 13791 |
BS 5977-2:1983 | Lintels Specification for prefabricated lintels |
PD 6687-1:2010 | Background paper to the National Annexes to BS EN 1992-1 and BS EN 1992-3 |
BS 8007:1987 | CODE OF PRACTICE FOR DESIGN OF CONCRETE STRUCTURES FOR RETAINING AQUEOUS LIQUIDS |
BS 8298:1989 | Code of practice for design and installation of natural stone cladding and lining |
BS 8298:1994 | Code of practice for design and installation of natural stone cladding and lining |
PD 6686:2006 | Guidance on directives, regulations and standards related to prevention of fire and explosion in the process industries |
BS 5911-5(2004) : 2004 | CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 5: SPECIFICATION FOR PRESTRESSED NON-PRESSURE PIPES AND FITTINGS WITH FLEXIBLE JOINTS |
17/30342957 DC : 0 | BS 8297 - DESIGN, MANUFACTURE AND INSTALLATION OF ARCHITECTURAL PRECAST CONCRETE CLADDING - CODE OF PRACTICE |
BS 5911-110:1992 | Precast concrete pipes, fittings and ancillary products Specification for ogee pipes and fittings (including perforated) |
BS 5911-200:1989 | Precast concrete pipes, fittings and ancillary products Specification for unreinforced and reinforced manholes and soakaways of circular cross section |
BS 8006:1995 | Code of practice for strengthened/reinforced soils and other fills |
BS 8102:1990 | Code of practice for protection of structures against water from the ground |
BS 5911-120:1989 | Precast concrete pipes, fittings and ancillary products Specification for reinforced jacking pipes with flexible joints |
PD 6687:2006 | Background paper to the UK National Annexes to BS EN 1992-1 |
BS 8010-3:1993 | Code of practice for pipelines Pipelines subsea: design, construction and installation |
BS 5911-3(2010) : 2010 | CONCRETE PIPES AND ANCILLARY CONCRETE PRODUCTS - PART 3: SPECIFICATION FOR UNREINFORCED AND REINFORCED CONCRETE MANHOLES AND SOAKAWAYS (COMPLEMENTARY TO BS EN 1917:2002) |
BS 5975:1996 | Code of practice for falsework |
BS 5950-4:1994 | STRUCTURAL USE OF STEELWORK IN BUILDING - PART 4: CODE OF PRACTICE FOR DESIGN OF COMPOSITE SLABS WITH PROFILED STEEL SHEETING |
BS 8500-2:2002 | Concrete. Complementary British Standard to BS EN 206-1 Specification for constituent materials and concrete |
BS 8007:1987 | CODE OF PRACTICE FOR DESIGN OF CONCRETE STRUCTURES FOR RETAINING AQUEOUS LIQUIDS |
BS EN 197-1:2011 | Cement Composition, specifications and conformity criteria for common cements |
BS 8500-1:2002 | Concrete. Complementary British Standard to BS EN 206-1 Method of specifying and guidance for the specifier |
BS 8666:2005 | Scheduling, dimensioning, bending and cutting of steel reinforcement for concrete. Specification |
BS 6213(2000) : 2000 | SELECTION OF CONSTRUCTION SEALANTS - GUIDE |
BS 6089:1981 | Guide to assessment of concrete strength in existing structures |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.