BS EN 60717:2012
Current
The latest, up-to-date edition.
Method for the determination of the space required by capacitors and resistors with unidirectional terminations
Hardcopy , PDF
English
31-08-2012
Important note : Users cannot be edited or removed once added to your Multi user PDF.
1 Scope
2 Normative references
3 Gauge board
4 Width and length
5 Height
6 Information to be given in the relevant
specification
Annex A (informative) - Cross-reference
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Pertains to capacitors and resistors with unidirectional wire terminations intended for use in electronic equipment.
| Committee |
W/-
|
| DevelopmentNote |
Supersedes BS 6303(1982) & 10/30235870 DC. (08/2012)
|
| DocumentType |
Standard
|
| Pages |
14
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
| Supersedes |
IEC 60717:2012 applies to capacitors and resistors with unidirectional wire terminations intended for use in electronic equipment. This standard provides a method for determination of the space required by capacitors and resistors with unidirectional wire terminations. NOTE: Instead of measuring the actual space, it may be sufficient to ensure that a component fits into the maximum space for which it is designed. This may be achieved by means of fixed gauges. The main technical changes with respect to the first edition are the following:
- employment of the millimetre-based grid, the preferred grid system given in IEC 60097,
- employment of SI units only, causing deletion of the imperial dimensions from Table 1,
- reduction of the tolerance on the chamfer depth in Figure 1, and
- introduction of requirements on information to be given in a relevant specification.
| Standards | Relationship |
| IEC 60717:2012 | Identical |
| EN 60717:2012 | Identical |
| EN 60294:2012 | Measurement of the dimensions of a cylindrical component with axial terminations |
| EN 60301:2012 | Preferred diameters of wire terminations of capacitors and resistors |
| EN 60097:1993 | Grid systems for printed circuits |
| IEC 61192-3:2002 | Workmanship requirements for soldered electronic assemblies - Part 3: Through-hole mount assemblies |
| IEC 60097:1991 | Grid systems for printed circuits |
| IEC 60294:2012 | Measurement of the dimensions of a cylindrical component with axial terminations |
| IEC 60301:2012 | Preferred diameters of wire terminations of capacitors and resistors |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.