BS EN ISO 14998:2013

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Functional specification
6 Technical specification
7 Supplier/manufacturer requirements
8 Redress and repair
9 Shipment and storage
Annex A (normative) - Validation test requirements
Annex B (normative) - Validation test requirements for
        disconnect/reconnect functionality
Annex C (normative) - Validation test requirements for
        tubing movement functionality
Annex D (normative) - Validation test requirements for
        opening a port functionality
Bibliography

Specifies requirements and guidelines for completion accessories, as defined herein for use in the petroleum and natural gas industry.

This International Standard provides requirements and guidelines for completion accessories, as defined herein for use in the petroleum and natural gas industry. This International Standard provides requirements for the functional specification and technical specifications including: design, design verification and validation, materials, documentation and data control, redress, repair, shipment, and storage. This International Standard covers the pressure containing, load bearing, disconnect/reconnect, tubing movement, and opening a port functionalities of completion accessories.

Products covered under ISO11960, ISO10432, ISO10423, ISO14310, ISO16070, ISO28781, ISO10407-2, ISO17824, and ISO17078-1 are not included. Also not included are other products such as: liner/tubing hangers, down-hole well test tools, inflow control devices, surface controlled sliding sleeves and chokes, down-hole artificial lift equipment, and all functionalities relating to electronics. This International Standard does not cover the connections to the well conduit. Installation of these products is outside the scope of this International Standard.