BS ISO 12151-6:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Performance requirements
5 Designation of hose fittings
6 Design
7 Manufacture
8 Assembly instructions
9 Procurement information
10 Marking
11 Identification statement (reference to this part of
   ISO 12151)
Bibliography

Describes the general and dimensional requirements for the design and performance of hose fittings made of carbon steel with 60 degree cone ends for hose sizes 5 to 51 inclusive, in accordance with ISO 4397.

This part of ISO 12151 specifies the general and dimensional requirements for the design and performance of hose fittings made of carbon steel with 60° cone ends for hose sizes 5 to 51 inclusive, in accordance with ISO 4397.

These hose fittings (see Figure 1 for a typical example) are for use in hydraulic fluid power systems with hoses that meet the requirements of the respective hose standards and in general applications with suitable hoses.

NOTE 1 Other materials can be supplied as agreed between the manufacturer and user.

NOTE 2 For hose fittings used in hydraulic and pneumatic braking systems on road vehicles (as defined in the scope of ISO/TC 22), see ISO 4038, ISO 4039-1 and ISO 4039-2.