BS ISO 8132:2014

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Mounting dimensions
5 Tolerances
6 Application instructions
7 Designation
8 Identification statement (reference to this
  International Standard)
Bibliography

Defines the mounting dimensions required for the interchangeability of accessories for 16 MPa (160 bar) medium series cylinders in accordance with ISO 6020-1 and for 25 MPa (250 bar) series cylinders, in accordance with ISO 6022.

This International Standard specifies the mounting dimensions required for the interchangeability of accessories for 16MPa [160bar] medium series cylinders in accordance with ISO6020-1 and for 25MPa (250bar) series cylinders, in accordance with ISO6022. The accessories have been designed specifically for use with cylinders manufactured in accordance with ISO6020-1 and ISO6022, but this does not limit their application.

NOTE 1bar=0,1MPa=10⁵Pa; 1MPa=1N/mm²

This International Standard covers the following accessories, identified in accordance with ISO6099:

• AP2— rod clevis, female thread (see Figure1 and Table1);

• AF3— rod flange, circular (see Figure2 and Table2);

• AB4— clevis bracket, straight (see Figure3 and Table3);

• AB3— clevis bracket, in angle (see Figure4 and Table4);

• AT4— trunnion bracket (see Figure5 and Table5);

• AA4-R— pivot pin, plain (cotter pin or snap ring type) (see Figure6 and Table6);

• AA4-S — pivot pin, plain (split pins) (see Figure7 and Table7);

• AA6-R — pivot pin, spherical bearing (cotter pin or snap ring type) (see Figure6 and Table6);

• AA6-S— pivot pin, spherical bearing (split pins) (see Figure7 and Table7);

• AP6— rod eye spherical, female thread (see Figure8 and Table8);

• AP4— rod eye plain, female thread (see Figure9 and Table9).

These accessories are used on hydraulic cylinders for mechanically transmitting the cylinder force. The design of these accessories is based on the maximum forces resulting from the specified internal diameters of the cylinders and pressures according to ISO3320 and ISO3322.

This International Standard applies only to the dimensional criteria of products manufactured in conformity with this International Standard; it does not apply to their functional characteristics.