CSA C391 : 2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TESTING OF THREE-PHASE SYNCHRONOUS MACHINES DURING REFURBISHMENT
Hardcopy , PDF
06-03-2020
English, French
01-01-2015
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Preface
0 Introduction
1 Scope
2 Reference publications
3 Definitions
4 Safety for inspections and tests
5 Test conditions, equipment, and instrumentation
6 Summary of inspection and test
7 Incoming inspection
8 DC resistance test of stator winding
9 Stator core magnetic circuit (laminations) testing
10 Salient pole piece testing
11 No-load testing and inspection
12 Supplementary tests
Annex A (informative) - Special tables, charts and reports
Annex B (informative) - Additional factors that help maintain
or enhance efficiency
Annex C (informative) - Synchronous motor fundamentals
Annex D (informative) - Other large motor technologies
Annex E (informative) - Synchronous generators
Annex F (informative) - MLT Definition
Annex G (informative) - Synchronous machine exciter systems
and amortisseur windings
Annex H (informative) - V curves for typical synchronous
motors with a variable excitation
Annex I (informative) - Bibliography
Includes three-phase, alternating current, salient pole synchronous machines 150 kW and up, 200 through 13,800 volts, 60 and 50 Hertz and will assist in verifying the machine efficiency has been maintained.
| DevelopmentNote |
French Edition issued on 01-06-2015. (07/2015)
|
| DocumentType |
Standard
|
| Pages |
54
|
| PublisherName |
Canadian Standards Association
|
| Status |
Superseded
|
| SupersededBy |
| ISO/IEC 17025:2005 | General requirements for the competence of testing and calibration laboratories |
| NEMA MG 1 : 2016 | MOTORS AND GENERATORS |
| ANSI/NCSL Z540 1 : 94(R2002) | CALIBRATION - CALIBRATION LABORATORIES AND MEASURING AND TEST EQUIPMENT - GENERAL REQUIREMENTS |
| IEC 60034-2-1:2014 | Rotating electrical machines - Part 2-1: Standard methods for determining losses and efficiency from tests (excluding machines for traction vehicles) |
| IEEE 115-2009 REDLINE | IEEE Guide for Test Procedures for Synchronous Machines Part I—Acceptance and Performance Testing Part II—Test Procedures and Parameter Determination for Dynamic Analysis |
| CSA C22.2 No. 100 : 2014 | MOTORS AND GENERATORS |
| IEEE 1068-2015 | IEEE Standard for the Repair and Rewinding of AC Electric Motors in the Petroleum, Chemical, and Process Industries |
| IEEE 43-2013 REDLINE | IEEE Recommended Practice for Testing Insulation Resistance of Electric Machinery |
| ISO 10012-1:1992 | Quality assurance requirements for measuring equipment Part 1: Metrological confirmation system for measuring equipment |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.