EN 1254-6:2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Testing, assessment and sampling methods
6 Evaluation of conformity
7 Classification and designation
8 Marking
9 Documentation
Annex A (normative) - Method for testing leaktightness
        of joints under internal hydrostatic pressure
Annex B (normative) - Method for testing resistance to
        pull-out of joints with metallic tube
Annex C (normative) - Test method for resistance of
        joints with metallic tube to temperature cycling
Annex D (normative) - Method for testing the resistance
        of joints with metallic tube to pressure cycling
Annex E (normative) - Test method for leaktightness of
        joints with metallic tube under vacuum
Annex F (normative) - Test method for the resistance
        of joints with metallic tube to vibration
Annex G (normative) - Test method for leaktightness of
        joints with metallic tube under internal hydrostatic
        pressure while subjected to bending
Annex H (normative) - Test method for disconnection
        and re-use
Annex I (normative) - Fitting rotation test
Annex J (normative) - Determination of resistance to
        stress corrosion
Annex K (normative) - Pressure test for fittings bodies
        with as-cast microstructure or fabricated by welding
        or brazing
Annex L (normative) - Determination of mean depth of
        dezincification
Bibliography

This European Standard specifies materials and test requirements for fittings of copper and copper alloys.This part of EN 1254 specifies push-fit end connections with or without plating or coating in the size range 6 mm to 54 mm for the purpose of joining tubes of copper, plated copper, multilayer pipes and plastics pipes, intended for use in hot or cold or combined hot and cold water systems, heating and cooling.Permissible operating temperatures and maximum operating pressures are also established.Fittings may comprise a combination of end types, specified in this standard, EN 1254, or other standards.The standard establishes a designation system for the fittings.This European Standard is applicable to push-fit fittings for joining one or more of the following tubes or pipes:-Copper tubes to EN 1057;-PE-X pipes to EN ISO 15875-2;-PB pipes to EN ISO 15876-2;-PP pipes to EN ISO 15874-2.-Multilayer pipes to EN ISO 21003-2.Fittings may be suitable for joining other tubes and pipes provided the push-fit joint with the specified tube or pipe meets the requirements of this standard.