EN 12717:2001+A1:2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective
  measures
6 Verification of safety requirements and/or
  protective measures
7 Information for use
Annex A (informative) - Illustrative figures used as examples
Annex B (normative) - Noise emission measurement
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 97/37/EC, amended by Directive 98/79/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

1.1This standard specifies the technical safety requirements and measures to be adopted by persons undertaking the design, construction and supply (including installation and dismantling, with arrangements for transport and maintenance) of stationary drilling machines (see 3.1).This standard covers both manual and automatic drilling machines. These include but are not limited to:-pedestal drilling machines (see figure A.1);-radial arm drilling machines (see figure A.2);-coordinate table drilling machines (see figure A.3);-horizontal spindle drilling machines (see figure A.4);-multi-spindle drilling machines (see figure A.5)-turret type drilling machines with manual control of turret index.1.2This standard takes account of intended use including reasonably foreseeable misuse, maintenance, cleaning, and setting operations. It presumes access to the machine from all directions. It describes means to reduce risks to operators and other exposed persons.1.3This standard also applies to workpiece transfer devices when they form an integral part of the machine.1.4This standard deals with significant hazards relevant to drilling machines when they are used as intended and under the conditions foreseen by the manufacturer (see clause 4).1.5Hazards arising from other metal working processes (e.g. milling, grinding, turning, forming, EDM, laser processing) are covered by other standards (see Bibliography).1.6Automatic drilling machines with automatic tool changing capabilities are not covered by this standard (see prEN 12417:1996).1.7This standard is not applicable to drilling machines, which were manufactured before the date of publication by CEN of this standard.