EN ISO 13628-10:2006

Foreword
Introduction
1 Scope
   1.1 Purpose
   1.2 Products
   1.3 Applications
2 Normative references
3 Terms, definitions and abbreviations
   3.1 Terms and definitions
   3.2 Symbols and abbreviations
4 Functional requirements
   4.1 General
   4.2 Overall requirements
   4.3 General design parameters
   4.4 Internal fluid parameters
   4.5 External environment
   4.6 System requirements
5 Design requirements
   5.1 Loads and load effects
   5.2 Pipe design methodology
   5.3 Pipe structure design
   5.4 System design requirements
6 Materials
   6.1 Material requirements
   6.2 Qualification requirements
   6.3 Quality assurance requirements
7 Manufacturing requirements
   7.1 Quality assurance requirements
   7.2 Carcass
   7.3 Preparation of compound and calendering
   7.4 Elastomer winding
   7.5 Reinforcement armour layer
   7.6 Insulation layers
   7.7 End fitting
   7.8 Curing process
   7.9 Special processes
   7.10 Manufacturing tolerances
   7.11 Repairs
8 Documentation
   8.1 General
   8.2 Design premise
   8.3 Design load report
   8.4 Design report
   8.5 Manufacturing quality plan
   8.6 Fabrication specification
   8.7 As-built documentation
   8.8 Operation manual
9 Factory acceptance tests
   9.1 General
   9.2 Gauge test
   9.3 Hydrostatic pressure test
   9.4 Electrical continuity and resistance tests
   9.5 Kerosene test
   9.6 Vacuum test
10 Marking and packaging
   10.1 Marking
   10.2 Packaging
Annex A (informative) Purchasing guidelines
Annex B (informative) Bend stiffeners and bend restrictors
Annex C (informative) Use of the API Monogram
Bibliography

ISO 13628-10:2005 defines the technical requirements for safe, dimensionally and functionally interchangeable bonded flexible pipes that are designed and manufactured to uniform standards and criteria. Minimum requirements are specified for the design, material selection, manufacture, testing, marking and packaging of bonded flexible pipes, with reference to existing codes and standards where applicable.ISO 13628-10:2005 applies to bonded flexible pipe assemblies, consisting of segments of flexible pipe body with end fittings attached to both ends.ISO 13628-10:2005 applies to pipes with a design pressure greater than or equal to 1,5 MPa (15 bar). ISO 13628-10:2005 can be used for lower design pressure pipes, though the requirements of these pipes have not been specifically addressed.ISO 13628-10:2005 does not cover flexible pipes of unbonded structure nor to flexible pipe ancillary components and does not apply to flexible pipes for use in choke and kill line applications..ISO 13628-10:2005 can be applied to flexible pipes that include non-metallic reinforcing layers, though no effort was made to address the specific and unique technological aspects of this product, and to a bonded construction pipe that includes a material or layer construction that is covered in ISO 13628-2.ISO 13628-10:2005 can be applied to flexible pipes for pile hammer, gas flare, water supply and jetting applications, though no effort was made to address the specific and unique technological aspects relating to each of these requirements.