EN ISO/TS 15694 : 2004

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Parameters for describing single shocks
  4.1 Acceleration
  4.2 Flat[h]-weighted acceleration
  4.3 Root-mean-square value of flat[h]-weighted
       acceleration
  4.4 Running root-mean-square value of flat[h]-weighted
       acceleration
  4.5 Root-mean-quad value of flat[h]-weighted acceleration
  4.6 Maximum transient vibration value of flat[h]-weighted
       acceleration
  4.7 Peak value of flat[h]-weighted acceleration
  4.8 Crest factor of flat[h]-weighted acceleration
  4.9 Shock content quotient of flat[h]-weighted
       acceleration
  4.10 W[h]-weighted acceleration
  4.11 Root-mean-square value of W[h]-weighted acceleration
  4.12 Root-mean-quad value of W[h]-weighted acceleration
  4.13 Shock content quotient of W[h]-weighted acceleration
5 Measuring instrumentation
6 Measurement procedure
  6.1 Attaching accelerometers
  6.2 Orientation of accelerometers
  6.3 Working procedure
7 Measurement report
Annex A (normative) Requirements and test methods for
        the measuring instrumentation
Annex B (informative) Recommendations and test methods
        for a digital measuring instrumentation
Annex C (informative) Alternative parameter to describe
        single shocks
Annex D (normative) Filter for flat[h] frequency weighting
Annex E (normative) Filter for frequency weighting W[h]
        from EN ISO 5349-1
Bibliography

ISO/TS 15694:2004 specifies methods for measuring single shocks at the handle(s) of hand-held and hand-guided machinery characterized by a maximum strike rate below 5 Hz.