• IEC 61046:1993

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    D.C. or a.c. supplied electronic step-down convertors for filament lamps - General and safety requirements

    Available format(s):  Hardcopy, PDF, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  13-10-2000

    Language(s): 

    Published date:  11-11-1993

    Publisher:  International Electrotechnical Committee

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Contents
    Foreword
    Section 1 - General requirements
    1. General
    1.1 Scope
    1.2 Normative references
    2. Definitions
    3. General requirements
    4. General notes on tests
    5. Classification
    6. Marking
    Section 2 - Safety requirements
    7. Terminals
    8. Provisions for earthing
    9. Construction
    10. Creepage distances and clearances
    11. Protection against accidental contact with live parts
    12. Moisture resistance and insulation
    13. Electric strength
    14. Transformer heating
    15 Abnormal conditions
    16. Fault conditions
    17. Screws, current-carrying parts and connections
    18. Resistance to heat and fire
    19. Resistance to corrosion
    Figure 1
    Annexes
    A. Test to establish whether a conductive part is a
         live part which may cause an electric shock
    B. Particular requirements for d.c. or a.c. supplied
         electronic step-down convertors for filament lamps
         with means of protection against overheating
    C. Particular additional requirements for independent
         SELV d.c. or a.c. supplied electronic step-down
         convertors for filament lamps

    Abstract - (Show below) - (Hide below)

    Specifies general and safety requirements for electronic step-down convertors for use on d.c. supplies up to 250 V or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz.

    General Product Information - (Show below) - (Hide below)

    Committee TC 34/SC 34C
    Development Note BS DRAFTS 93/211259 DC AND 94/202328 DC REFER TO AMENDMENT
    Document Type Standard
    Publisher International Electrotechnical Committee
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    PREN 12665 : DRAFT 2009 LIGHT AND LIGHTING - BASIC TERMS AND CRITERIA FOR SPECIFYING LIGHTING REQUIREMENTS
    CEI EN 60598-2-6 : 1998 LUMINAIRES - PART 2: PARTICULAR REQUIREMENTS - SECTION 6: LUMINAIRES WITH BUILT-IN TRANSFORMERS FOR FILAMENT LAMPS
    VDE 0711-2-23 : 2001 LUMINAIRES - PART 2-23: PARTICULAR REQUIREMENTS - EXTRA LOW-VOLTAGE LIGHTING SYSTEMS FOR FILAMENT LAMPS
    10/30217290 DC : DRAFT FEB 2010 BS EN 60364-7-715 - LOW-VOLTAGE ELECTRICAL INSTALLATIONS - PART 7-715: REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS - EXTRA-LOW-VOLTAGE LIGHTING INSTALLATIONS
    HD 384.7.711 : 200S1 ELECTRICAL INSTALLATIONS OF BUILDINGS - PART 7-711: REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS - EXHIBITIONS, SHOWS AND STANDS
    I.S. EN 60598-2-6:1995 LUMINAIRES - PART 2: PARTICULAR REQUIREMENTS - SECTION 6: LUMINAIRES WITH BUILT-IN TRANSFORMERS OR CONVERTERS FOR FILAMENT LAMPS
    NF EN 60598 2-23 : 97 AMD 1 2001 LUMINARIES - PART 2: PARTICULAR REQUIREMENTS - SECTION 23: EXTRA LOW-VOLTAGE LIGHTING SYSTEMS FOR FILAMENT LAMPS
    EN 60598-2-23:1996/A1:2000 LUMINAIRES - PART 2-23: PARTICULAR REQUIREMENTS - EXTRA LOW VOLTAGE LIGHTING SYSTEMS FOR FILAMENT LAMPS
    VDE 0711-223 : 1997 LUMINAIRES - PART 2: PARTICULAR REQUIREMENTS - SECTION 23: EXTRA LOW-VOLTAGE LIGHTING SYSTEMS FOR FILAMENT LAMPS
    09/30185891 DC : 0 BS EN 12665 - LIGHT AND LIGHTING - BASIC TERMS AND CRITERIA FOR SPECIFYING LIGHTING REQUIREMENTS
    I.S. HD 384.7.711:2003 ELECTRICAL INSTALLATIONS OF BUILDINGS - PART 7-711: REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS - EXHIBITIONS, SHOWS AND STANDS
    CSA E598.1 : 2002 LUMINAIRES - PART 1: GENERAL REQUIREMENTS AND TESTS
    IEC 60364-7-740:2000 Electrical installations of buildings - Part 7-740: Requirements for special installations or locations - Temporary electrical installations for structures, amusement devices and booths at fairgrounds, amusement parks and circuses
    I.S. HD 60364-7-740:2006 ELECTRICAL INSTALLATIONS OF BUILDINGS - PART 7-740: REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS - TEMPORARY ELECTRICAL INSTALLATIONS FOR STRUCTURES, AMUSEMENT DEVICES AND BOOTHS AT FAIRGROUNDS, AMUSEMENT PARKS AND CIRCUSES
    IEC 60598-2-23:1996+AMD1:2000 CSV Luminaires - Part 2-23: Particular requirements - Extra low voltage lighting systems for filament lamps
    BS EN 60598-2-23:1997 Luminaires. Particular requirements Extra low voltage lighting systems for filament lamps
    S.R. HD 60364-7-740:2006 ELECTRICAL INSTALLATIONS OF BUILDINGS - PART 7-740: REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS - TEMPORARY ELECTRICAL INSTALLATIONS FOR STRUCTURES, AMUSEMENT DEVICES AND BOOTHS AT FAIRGROUNDS, AMUSEMENT PARKS AND CIRCUSES
    IEC 60598-2-6:1994 Luminaires - Part 2: Particular requirements - Section 6: Luminaires with built-in transformers for filament lamps
    EN 60598-2-6:1994/A1:1997 LUMINAIRES - PART 2: PARTICULAR REQUIREMENTS - SECTION 6: LIMINAIRES WITH BUILT-IN TRANSFORMERS OR CONVERTERS FOR FILAMENT LAMPS
    HD 60364-7-740:2006/A11:2017 ELECTRICAL INSTALLATIONS OF BUILDINGS - PART 7-740: REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS - TEMPORARY ELECTRICAL INSTALLATIONS FOR STRUCTURES, AMUSEMENT DEVICES AND BOOTHS AT FAIRGROUNDS, AMUSEMENT PARKS AND CIRCUSES

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 60730-2-3:2006 Automatic electrical controls for household and similar use - Part 2-3: Particular requirements for thermal protectors for ballasts for tubular fluorescent lamps
    IEC 60127:1974 Cartridge fuse-links for miniature fuses
    IEC 60695-2-1:1991 Fire hazard testing - Part 2: Test methods - Section 1: Glow-wire test and guidance
    IEC 60364-4-41:2005+AMD1:2017 CSV Low voltage electrical installations - Part 4-41: Protection for safety - Protection against electric shock
    IEC 60269-2:2013+AMD1:2016 CSV Low-voltage fuses - Part 2: Supplementary requirements for fuses for use by authorized persons (fuses mainly for industrial application) - Examples of standardized systems of fuses A to K
    IEC 61047:2004 DC or AC supplied electronic step-down convertors for filament lamps - Performance requirements
    IEC 60085:2007 Electrical insulation - Thermal evaluation and designation
    IEC 60529:1989+AMD1:1999+AMD2:2013 CSV Degrees of protection provided by enclosures (IP Code)
    IEC 60269-3:2010+AMD1:2013 CSV Low-voltage fuses - Part 3: Supplementary requirements for fuses foruse by unskilled persons (fuses mainly for household or similar applications) - Examples of standardized systems of fuses A to F
    IEC 60691:2015 Thermal-links - Requirements and application guide
    IEC 60598-1:2014+AMD1:2017 CSV Luminaires - Part 1: General requirements and tests
    ISO 4046:1978 Paper, board, pulp and related terms — Vocabulary
    IEC 60051:1973 Recommendations for direct acting indicating electrical measuring instruments and their accessories
    IEC 60920:1990 Ballasts for tubular fluorescent lamps - General and safety requirements
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective