09/30202029 DC : 0

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protective measures
  5.1 General
  5.2 Strength and stability
  5.3 Equipment and components
  5.4 Drive systems
  5.5 Control station
  5.6 Noise reduction
  5.7 Access, guards etc.
  5.8 Controls, indicators and limiting devices
  5.9 Protection system
  5.10 Lifting of personnel
6 Verification of the safety requirements and/or
  protective measures
  6.1 General
  6.2 Testing
7 Information for use
  7.1 Documentation
  7.2 Operation
  7.3 Maintenance
  7.4 Marking
Annex A (normative) - Selection of a suitable set of crane
        standards for a given application
Annex B (normative) - Determination of factors
  B.1 Calculation of the dynamic coefficient phi[n]
       by the simplified method
  B.2 Calculation of dynamic coefficient phi[n]
       by motion response analysis
  B.3 Out of plane influences
  B.4 Hook velocity
  B.5 Load combinations
Annex C (normative) - Environmental influences
  C.1 General
  C.2 Wind
  C.3 Floating units
  C.4 Thermal effects
  C.5 Ice
  C.6 Stowage
  C.7 Corrosion protection
Annex D (normative) - Failure mode analysis
  D.1 General
  D.2 Failure mode charts
Annex E (normative) - Material selection
  E.1 General
  E.2 Verification of material quality
  E.3 Forged rings for slewing bearings
  E.4 Slewing bearing fasteners
  E.5 Welded structures
  E.6 Non-welded components
Annex F (informative) - Control station instrumentation
Annex G (normative) - Wire rope safety factors
  G.1 General
  G.2 Static safety factors
  G.3 Dynamic safety factors
  G.4 Lifting of personnel
Annex H (normative) - Slewing bearings
Annex I (normative) - Requirements for brakes
Annex J (normative) - Ranking of safety systems
Annex K (normative) - Required performance levels (PLr)
        for SRP/CS according to EN ISO 13849-1:2008
Annex L (informative) - Typical general-purpose offshore
        cranes and terminology
Annex M (normative) - Design excursion envelopes
Annex N (normative) - Noise test code
  N.1 Introduction
  N.2 Sound power level determination
  N.3 Emission sound pressure level determination
  N.4 Operating conditions
  N.5 Information on measurement uncertainties
  N.6 Information to be recorded
  N.7 Information to be reported
  N.8 Declaration and verification of noise emission values
  N.9 Noise measurement - test report
Annex O (normative) - Equipment for use in a hazardous area
  O.1 General
  O.2 Avoidance or reduction of ignition sources
  O.3 Electro technical equipment
  O.4 Non-electro technical equipment
  O.5 Electrostatic discharge
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/EC

BS EN 13852-1