BS EN 12101-10:2005

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
   3.1 Terms and definitions
   3.2 Abbreviations
4 General requirements (electrical)
   4.1 General
   4.2 Batteries
   4.3 Generator sets
5 General requirements (pneumatic)
   5.1 General
   5.2 Power sources
6 Functions
   6.1 Power supply from the primary power source (electrical)
   6.2 Power supply from the secondary power source (battery)
   6.3 Power supply from the secondary power source (generators)
   6.4 Recognition and indication of faults (electrical)
   6.5 Power supply from compressed gases
7 Materials, design and manufacture
   7.1 Mechanical design
   7.2 Electrical design
8 Classification
9 Documentation
   9.1 User's documentation
   9.2 Design documentation
10 Marking
   10.1 General
   10.2 Gas bottles
11 General test requirements
   11.1 Standard atmospheric conditions for testing
   11.2 Mounting and orientation
   11.3 Electrical connection
   11.4 Selection of tests
12 Tests
   12.1 Electrical functional test
   12.2 Pneumatic functional test
   12.3 Test of the charger and the secondary power source
   12.4 Cold (operational)
   12.5 Damp heat, steady state (operational)
   12.6 Impact (operational)
   12.7 Vibration, sinusoidal (operational)
   12.8 Damp heat, steady state (endurance)
   12.9 Vibration, sinusoidal (endurance)
   12.10 Dry heat (operational)
   12.11 SO[2] corrosion
   12.12 Salt spray testing
   12.13 Protection against water
   12.14 Protection against solid foreign objects
   12.15 EMC immunity tests (operational)
13 Evaluation of conformity
   13.1 General
   13.2 Initial type testing
   13.3 Factory production control (FPC)
Annex A (informative) Summary of functions
Annex ZA (informative) Clauses of this European Standard addressing
         the provisions of the EU Construction Products Directive
      ZA.1 Scope and relevant characteristics
      ZA.2 Procedure for attestation of conformity of power supply
           equipment
           ZA.2.1 System of attestation of conformity
           ZA.2.2 EC Certificate and Declaration of conformity
      ZA.3 CE marking and labelling

Describes requirements and gives test methods for primary and secondary electrical and pneumatic power supply equipment, designed for use in smoke and heat control systems in buildings. It also provides for the evaluation of conformity of such equipment to the requirements of this European Standard.

This European Standard specifies requirements and gives test methods for primary and secondary electrical and pneumatic power supply equipment, designed for use in smoke and heat control systems in buildings. It also provides for the evaluation of conformity of such equipment to the requirements of this European Standard.

NOTE A summary of functions is given in Annex A.