BS EN 12206-1:2004

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Test methods
Annex A (normative) Methods for the determination of the mass
        per unit area of conversion layers and for the
        identification of chromium, phosphorus and zinc
Annex B (normative) Requirements for alternative pretreatment
Annex C (normative) Measurement of film thickness
Annex D (normative) Falling weight test apparatus
Annex E (informative) Sequence of pretreatment stages
Annex F (normative) Enhanced durability coating powders
Bibliography

Describes the requirements and the corresponding methods of test relating to the organic coating of aluminium and aluminium alloy extrusions, sheet and preformed sections for architectural purposes, using coating powders.

This Part of EN 12206 specifies requirements and the corresponding methods of test relating to the organic coating of aluminium and aluminium alloy extrusions, sheet and preformed sections for architectural purposes, using coating powders. It also describes: the pretreatment of the substrate prior to the coating process; the coating powder; the coating process; the final product. Each item is dealt with separately in this Part of EN 12206 so that any interested party can ensure compliance appropriate to its area of responsibility. CAUTION — The procedures described in this standard are intended to be carried out by suitably trained and/or supervised personnel. The substances and procedures used in this method may be injurious to health if adequate precautions are not taken. Attention is drawn in the text to specific hazards. This standard refers only to technical suitability and does not absolve the user from statutory obligations relating to health and safety.