BS EN ISO 13533:2002

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviated terms
5 Design requirements
   5.1 Size designation
   5.2 Service conditions
   5.3 Equipment-specific design requirements
   5.4 Design methods
   5.5 Design verification testing
   5.6 Documentation
   5.7 Tests for BOP and hydraulic connector
        operational characteristics
   5.8 Design temperature verification testing for
        non-metallic sealing materials and moulded
        sealing assemblies
   5.9 Operating manual requirements
6 Material requirements
   6.1 General
   6.2 Written specifications
   6.3 Pressure-containing members
7 Welding requirements
   7.1 General
   7.2 Weldment design and configuration
   7.3 Welding controls
   7.4 Welding procedure and performance qualifications
   7.5 Other requirements
8 Quality control requirements
   8.1 General
   8.2 Measuring and testing equipment
   8.3 Quality control personnel qualifications
   8.4 Quality control requirements for equipment and
        parts
   8.5 Quality control requirements for specific
        equipment and parts
   8.6 Requirements for quality control records
9 Marking requirements
   9.1 General
   9.2 Types of identification stamping
   9.3 Specific codification requirements of equipment
   9.4 Product description code (PDC)
10 Storing and shipping
   10.1 Storing for periods greater than 30 days
   10.2 Shipping
Annex A (normative) - Qualification of heat-treating
        equipment
Annex B (normative) - Requirements for repair and
        remanufacture
Annex C (informative) - Operational characteristics
        test procedure
Annex D (informative) - Procedure for design temperature
        verification testing
Annex E (informative) - Purchasing guidelines
Annex F (informative) - Failure reporting
Annex G (informative) - Conversion of US Customary units
        to the SI system (metric)
Annex H (informative) - List of national/regional
        standards applicable in context
Annex ZA (normative) - Normative references to international
         publications with their relevant European
         publications
Bibliography

Describes requirements for performance, design, materials, testing and inspection, welding, marking. handling, storing and shipping of drill-through equipment used for drilling for oil and gas. It also specifies service conditions in terms of pressure, temperature and wellbore fluids for which the equipment will be designed.

This International Standard specifies requirements for performance, design, materials, testing and inspection, welding, marking, handling, storing and shipping of drill-through equipment used for drilling for oil and gas. It also defines service conditions in terms of pressure, temperature and wellbore fluids for which the equipment will be designed. This International Standard is applicable to and establishes requirements for the following specific equipment: ram blowout preventers; ram blocks, packers and top seals; annular blowout preventers; annular packing units; hydraulic connectors; drilling spools; adapters; loose connections; clamps. Dimensional interchangeability is limited to end and outlet connections. Typical equipment defined by this International Standard is shown in Figures 1 and 2; recommendations for failure reporting are outlined in annex F. This International Standard does not apply to field use or field testing of drill-through equipment.