EN 61514:2002

FOREWORD
1 Scope and object
2 Normative references
3 Definitions
4 General conditions for tests
  4.1 Environmental test conditions
  4.2 Supply conditions
5 General testing procedures
  5.1 Test equipment
  5.2 Test methods
  5.3 Testing precaution
  5.4 Basic test arrangement
  5.5 Initial setting-up
6 Test procedures
  6.1 Gain characteristic
  6.2 Travel characteristic
  6.3 Accuracy related terms
  6.4 Dead band
  6.5 Airflow data
  6.6 Effects of influence quantities
  6.7 Input over-range
  6.8 Drift
  6.9 Accelerated life test
  6.10 Dynamic response
7 Other considerations
  7.1 General
  7.2 Safety
  7.3 Degree of protection provided by enclosures
  7.4 Documentary information
  7.5 Installation
  7.6 Routine maintenance and adjustment
  7.7 Repair
  7.8 Protective finishes
  7.9 Design features
  7.10 Variants
  7.11 Tools and equipment
8 Test report and documentation
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications

IEC 61514:2000 specifies tests designed to determine the static and dynamic performance of single-acting or double-acting valve positioners. The tests may be applied to positioners which receive standard analogue input signals (as specified in IEC 60381 and IEC 60382) and have a pneumatic output.NOTE For positioners with pulsed or digital input signals, equivalent criteria may be applied. The methods described may not fully apply to positioners with digital controllers or positioners with pulsed outputs.Testing may be conducted either on a positioner alone, independently of an actuator, or on a positioner mounted and connected to a specific actuator, as a combined unit. The text makes clear where different approaches are required. The methods of evaluation given in this standard are intended for use by manufacturers to determine the performance of their products, and by users, or independent testing establishments, to verify manufacturers' performance specifications. This publication is to be read in conjunction with IEC 61514-2:2013.