DIN EN 13483:2013-09

National foreword
National Annex NA (informative) - Bibliography
Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Materials and construction
6 Pressure requirements
7 Dimensions and tolerances
8 Physical properties
9 End fittings
10 Type tests
11 Frequency of testing
12 Marking
Annex A (normative) - Test method for determination of low
        temperature class resistance at -30 degrees C (for
        normal temperature class) and -40 degrees C (for low
        temperature class)
Annex B (normative) - Test method for pressure requirements
        of vapour recovery hoses and tubes
Annex C (normative) - Test method for determination of
        change in length due to swelling
Annex D (normative) - Test method for determination of
        pressure loss
Annex E (normative) - Method for determination of adhesion
        between components
Annex F (normative) - Test method for the determination of
        low temperature flexibility
Annex G (normative) - Test method for the determination
        of rate of fuel permeation
Annex H (normative) - Test method for flammability
Annex I (normative) - Test method for the determination
        of leakage (leak test)
Annex J (normative) - Test method for fatigue strength under
        reversed bending stresses (flex test)
Annex K (normative) - End-fitting pull-off test
Annex L (normative) - Test frequency for type tests and routine
        tests
Annex M (informative) - Test frequency for production
        acceptance tests
Bibliography

This standard is included in DIN Handbook 380.