EN 14963:2006

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviations
5 Requirements
   5.1 Radiation transmittance
   5.2 Durability
   5.3 Water tightness
   5.4 Mechanical performances
   5.5 Reaction to fire
   5.6 Resistance to fire
   5.7 External fire performance
   5.8 Air permeability
   5.9 Thermal resistance
   5.10 Airborne sound insulation
6 Testing
   6.1 Radiation transmittance
   6.2 Durability
   6.3 Water tightness
   6.4 Mechanical performances
   6.5 Number and dimensions of test specimens
   6.6 Test report
7 Evaluation of conformity
   7.1 General
   7.2 Initial type testing
   7.3 Factory production control (FPC)
8 Classification and designation
9 Marking
Annex A (informative) Guidelines for safety, application, use
         and maintenance
   A.1 General
   A.2 Guidelines for safety
   A.3 Guidelines for application and use
   A.4 Maintenance
Annex B (normative) Alternative test method for determination
        of light transmittance
   B.1 General
   B.2 Apparatus
   B.3 Test pieces
   B.4 Procedure
   B.5 Expression of results
Annex C (informative) Information regarding light transmittance
   C.1 General
   C.2 Material characteristics
   C.3 Transmission
   C.4 Reflectance factor (according to CIE)
   C.5 Absorptance
   C.6 Solar gain
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of EU Construction Products
         Directive
   ZA.1 Scope and relevant characteristics
   ZA.2 Procedures for attestation of conformity of continuous
        rooflights
   ZA.3 CE marking and labelling
Bibliography

This European Standard specifies requirements for continuous rooflights made of plastic materials (e.g. GF-UP, PC, PMMA, PVC) with or without bearing profiles to be used with upstands made of e.g. GF-UP, PVC, steel, aluminium, wood or concrete, for laying in roofs, which serve the purpose of lighting by means of daylight and, possibly, of ventilating interior spaces by means of opening devices.This European Standard applies to continuous rooflights without upstand and to continuous rooflights, where a single manufacturer provides all components of the rooflight with upstand, which are bought in a single purchase. Products covered by this European Standard may be supplied as continuous rooflights with and without upstand and rooflights intended to be used with an upstand, for which the upstand is specified, but not supplied.It applies to continuous rooflights when mounted with an inclination  in the longitudinal direction not more than 10° to the horizontal and not more than 10° in the transversal direction (see Figure 1):a)with bearing profiles:symmetrical, angled, curved (see Figure 2) or flat (see Figure 3);constructed with bearing profiles parallel to the span and with a rectangular ground plan;b)without bearing profiles:symmetrical, angled or curved with an  angle not more than 45° (measured to the horizontal at the line of fixing, see Figure 4);constructed with a span (width) lower than or equal 2,5 m and with a rectangular ground plan.This European Standard applies to continuous rooflights, including barrel vault rooflights, with a rectangular ground plan of plastic glazing laying in roofs having, in addition a minimum distance of b/3 (b = effective span of rooflights, corresponding to the light opening). The upstands may be self-supporting or non self-supporting.The design of the upstand is not part of this European Standard. Upstands can be prefabricated or site fabricated. Prefabricated upstands are to be considered as p