EN 50110-1:2013

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Basic principles
5 Operational procedures
6 Working procedures
7 Maintenance procedures
Annex A (informative) - Guidance for distances in air
        for working procedures
Annex B (informative) - Additional information for
        safe working
Bibliography

This European Standard is applicable to all operation of and work activity on, with, or near electrical installations. These are electrical installations operating at voltage levels from and including extra-low voltage up to and including high voltage. This latter term includes those levels referred to as medium and extra-high voltage. These electrical installations are designed for the generation, transmission, conversion, distribution and use of electrical power. Some of these electrical installations are permanent and fixed, such as a distribution installation in a factory or office complex, others are temporary, such as on construction sites and others are mobile or capable of being moved either whilst energised or whilst not energised nor charged. Examples are electrically driven excavating machines in quarries or open-cast coal sites. This European Standard sets out the requirements for the safe operation of and work activity on, with, or near these electrical installations. The requirements apply to all operational, working and maintenance procedures. They apply to all non-electrical work activities such as building work near to overhead lines or underground cables as well as electrical work activities, when there is a risk of electrical danger. This European Standard does not apply to ordinary persons when using installations and equipment, provided that the installations and equipment comply with relevant standards and are designed and installed for use by ordinary persons. This European Standard has not been developed specifically to apply to the electrical installations listed below. However, if there are no other rules or procedures, the principles of this European Standard could be applied to them –on any aircraft and hovercraft moving under its own power, (these are subject to International Aviation laws which take precedence over national laws in these situations); –on any sea going ship moving under its own power, or under the direction of the master, (these are subject to International Marine laws which take precedence over national laws in these situations); –electronic telecommunications and information systems; –electronic instrumentation, control and automation systems; –at coal or other mines; –on off-shore installations subject to International Marine laws; –on vehicles; –on electric traction systems; –on experimental electrical research work.