EN ISO 13628-15:2011

Foreword
1 Scope
2 Normative references
3 Terms, abbreviated terms, and definitions
4 Manifold and template functional considerations
5 Design considerations
6 Verification and validation of design
7 Materials and fabrication requirements to piping systems
8 Fabrication and manufacturing considerations
9 Installation, operation and maintenance considerations
10 ROV/ROT aspects
11 Lifting considerations
12 Equipment marking
13 Transportation and storage
14 Abandonment provisions
Annex A (informative) - Typical manifold data sheet
Bibliography

ISO 13628-15:2011 addresses recommendations for subsea structures and manifolds, within the frameworks set forth by recognized and accepted industry specifications and standards. As such, it does not supersede or eliminate any requirement imposed by any other industry specification.ISO 13628-15:2011 covers subsea manifolds and templates utilized for pressure control in both subsea production of oil and gas, and subsea injection services.The following equipment falls within the scope of ISO 13628-15:2011:structural components and piping systems of subsea production systems, includingproduction and injection manifolds,modular and integrated single satellite and multiwell templates,subsea processing and subsea boosting stations,flowline riser bases and export riser bases (FRB, ERB),pipeline end manifolds (PLEM),pipeline end terminations (PLET),T- and Y-connection, andsubsea isolation valve (SSIV);structural components of subsea production system, includingsubsea controls and distribution structures and other subsea structures, andprotection structures associated with the above.ISO 13628-15:2011 is not applicable to pipeline and manifold valves, flowline and tie-in connectors, choke valves and production control systems.