National foreword
Committees responsible
1. Scope
2. General
2.1 Related documents
2.2 Recommended values of temperatures (preferred
values)
2.3 Recommended values of voltages and currents
(preferred values)
2.4 Terminal identification
2.5 Colour codes for type designation
2.5.1 For JEDEC type numbers
2.5.2 For PRO ELECTRON type numbers
2.5.3 Any other type numbers
3. Quality assessment procedures
3.1 Primary stage of manufacture
3.2 Structurally similar devices
3.2.1 Grouping for electrical tests
3.2.2 Grouping for dimensional, climatic and mechanical
inspections or tests
3.2.3 Grouping for endurance tests
3.3 Inspection requirements for qualification approval
3.4 Quality conformance inspection
3.4.1 Division into groups and sub-groups
Table I - Group A: Lot-by-lot
Table II - Group B: Lot-by-lot
Table III - Group C: Periodic
3.5 Group D tests
3.6 Screening
Table IV - Screening
3.7 Sampling requirements
Table V - Sampling requirements for Group A tests
Table VI - Sampling requirements for Groups B and
C tests, in which LTPD shall be used
4. Test and measurement procedures