EN 10034:1993
Current
The latest, up-to-date edition.
Structural steel I and H sections - Tolerances on shape and dimensions
15-09-1993
Foreword
1 Scope
2 Normative references
3 Definitions
4 Rolling tolerances for structural steel I and H
sections
5 Tolerance on mass
6 Tolerance on length
Annex A (informative) - Straightness measurement
This European standard specifies tolerances on shape dimensions and mass of structural steel I and H sections. These requirements do not apply to I and H sections rolled from stainless steel. These requirements do not apply to taper flange sections. Note: Until a European standard for dimensions of I and H beams is published, Euronorm 19 and Euronorm 53 or corresponding national standards may be used.
| Committee |
CEN/TC 459/SC 3
|
| DocumentType |
Standard
|
| PublisherName |
Comite Europeen de Normalisation
|
| Status |
Current
|
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.