EN 60662:2012

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General lamp requirements
5 Marking
6 Dimensions
7 Caps
8 Test requirements for lamp starting, warm-up, electrical
   and photometric characteristics
9 Information for ballast and ignitor design
10 Information for luminaire design
11 Maximum lamp outlines
12 Numbering system for lamp data sheets
Annex A (normative) - Waveshape of voltage pulses for lamp
        starting test (schematic drawings)
Annex B (informative) - Diagrammatic data sheets for location
        of lamp dimensions
Annex C (normative) - Guidance for determining quadrilateral
        diagrams
Annex D (normative) - Measurement of voltage increase at lamp
        terminals for luminaire design
Annex E (informative) - HPS lamp drop-out voltage measurement
        procedure
Annex F (normative) - Fixed settings of the ignition device
        and requirements for ignition
Annex G (normative) - Method of measuring electrical and
        photometrical characteristics
Annex H (normative) - Method of test for lumen maintenance
        and life
Annex I (informative) - Maximum lamp outlines
Annex J (normative) - Lamp data sheets
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European publications

IEC 60662:2011 specifies performance requirements for high-pressure sodium vapour lamps for general lighting purposes which comply with the safety requirements of IEC 62035. This second edition cancels and replaces the first edition published in 1980 and its amendments. It constitues a technical revision. Main items that required development of the 2nd edition of IEC 60662 are: - restriction to performance requirements. Safety requirements are given in IEC 62035: Discharge lamps (excluding fluorescent lamps) - Safety specifications; - introduction of a test device for ignition; - split of the lamp data sheets which make use of the test device and those which do not; - provisions for measurement during starting, measurement of electrical and photometrical characteristics and tests for lumen maintenance and life; - general review e.g. of maximum lamp outlines and alignment of data; - new order of data sheets by wattage.